MS3PRO vs AEM UEGO
Thread Starter
Junior Member
Joined: Aug 2017
Posts: 46
Total Cats: -8
From: Fort Riley, KS
MS3PRO vs AEM UEGO
hey guys, long time lurker here with a question. i got my ms3pro and my uego came not too long after. do i have to use the accessory port to wire the wideband into the ecu since the narrowband is only a single wire? which ports on the accesory plug would i have to use?
Reply
0
0
Junior Member
Joined: Feb 2018
Posts: 199
Total Cats: 30
From: Knoxville, TN
Do you have the AEM X series uego? That one has a positive and negative (ground) signal wire. I believe most other widebands just have a single signal wire.
That had me slightly confused when I installed my AEM X series. My OEM o2 plug is only one wire too. Therefore I just ran both signal wires to the options plug. Analog input and sensor ground, I think. I have the MS3 Pro PNP as well.
That had me slightly confused when I installed my AEM X series. My OEM o2 plug is only one wire too. Therefore I just ran both signal wires to the options plug. Analog input and sensor ground, I think. I have the MS3 Pro PNP as well.
Reply
0
0
Thread Starter
Junior Member
Joined: Aug 2017
Posts: 46
Total Cats: -8
From: Fort Riley, KS
Do you have the AEM X series uego? That one has a positive and negative (ground) signal wire. I believe most other widebands just have a single signal wire.
That had me slightly confused when I installed my AEM X series. My OEM o2 plug is only one wire too. Therefore I just ran both signal wires to the options plug. Analog input and sensor ground, I think. I have the MS3 Pro PNP as well.
That had me slightly confused when I installed my AEM X series. My OEM o2 plug is only one wire too. Therefore I just ran both signal wires to the options plug. Analog input and sensor ground, I think. I have the MS3 Pro PNP as well.
Reply
0
0
Thread Starter
Junior Member
Joined: Aug 2017
Posts: 46
Total Cats: -8
From: Fort Riley, KS
i’ll be installing the ecu this weekend and just tuning narrowband for this week but next weekend i start turbo installation. the wideband looked very complicated and the factory o2 is 1 wire which had me a little confused. ill probably opt for using the accessory port so it will be direct and smooth. i need to look around and see how exactly to make the wideband talk to the ecu through the accessory port
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
