MS3X testing with Jim Stim - No RPM Signal
Hi, newbie here, happy to have built me MS3X, now into the testing phase. Good news - TPS, MAT, O2, CLT all work nicely, however I don't seem to be able to get RPM
I have 1. Confirmed using led test I can get RPM on the JimStim 2. On the JimStim - Jumpered Primary Tach for VR signal, Jumpered 5V to Pullup on 2 and P, set dipswitch on for 2,3,6. 3. On the TS ignition control - setup spark mode = miata 99-05 Not sure what to try next, any help/ideas welcomed. Thanks very much |
did you send the second trigger to pin 32 of the expander board?
|
Originally Posted by Braineack
(Post 1115496)
did you send the second trigger to pin 32 of the expander board?
|
correct. im sure if you looked at the composite log you were getting the crank signal, but not cam.
|
Originally Posted by Braineack
(Post 1115571)
correct. im sure if you looked at the composite log you were getting the crank signal, but not cam.
|
under the diganostics tab, yes, and then wait for a record to show up (you should see 1 of 1 on the bottom, or something like that)
|
2 Attachment(s)
Originally Posted by Braineack
(Post 1115571)
correct. im sure if you looked at the composite log you were getting the crank signal, but not cam.
|
Post the composite log and your map
|
4 Attachment(s)
Originally Posted by Braineack
(Post 1115764)
Post the composite log and your map
|
I just found the composite logger - sorry missed this...Anyway i tried to save a file but the file was empty, in the left column it says empty read no data received from the controller
|
2 Attachment(s)
Some progress....
Found my JP7 jumper was not in place (I forgot the Cam is a Hall and the crank is a VR !) and after tweaking pot R11 I got a signal...Yay ! CL file attached. I still dont see a RPM signal on the main tach, but I think this is progress in the right direction now.... |
OK ! Got it ! Looks like I was running my primary tach at 5v not 12v, Tuner studio is now synced and I have RPM's to play with ! Thanks for your help Braineack ! It took some trial and error but with the tip about the composite log that really helped !
Is there anything like a check list for things to test once you have RPM's ? I feel like I'm ready to test some things out with the Jimstim but not sure where to begin... I'm also looking for a Fuel and spark table for a NA 1.8 with VVT, if anybody has anything close to get me started/running.... Thanks again ! |
All times are GMT -4. The time now is 11:26 AM. |
© 2024 MH Sub I, LLC dba Internet Brands