MSPNP 2 start help
4 Attachment(s)
Hi there,
I'm having an issue starting my car after having switched to my megasquirt and I'm hoping an extra set of eyes can catch a mistake I may have made. It turns and turns but I don't even get a sputter. I attached my tune and a datalog of the start. I used MS2-Extra Conversion Manual and http://www.msextra.com/doc/ms2extra/...n_Ignition.htm as my points of reference for navigating through Tunderstudio. Car is a 2000, have MSPNP 2, Deatschwerks 700cc injectors, Aem Uego and BEGI S1 kit. Thanks |
Did you not use the included CD to load TunerStudio with the pre-made project? Your tune file suggests you created your own project.
Go to File > Project > Project Properties (or control + p) Click on settings tab Ensure that MegaSquirt/Microsquirt selection is set to Microsquirt Module/MSPNP. |
Did you scale Required Fuel for your injectors?
How's your timing look? |
Ben- You're correct. In an effort to not make any mistakes I believe I over-thought the situation and confused myself and created my own. I flashed back to the map provided for 99-00 with the only change I made to the reqfuel but that didn't work either.
The selection is the microsquirt/MSPNP. Does that make sense, it was purchased from 949Racing...the other selection is the MS 2 v3 that it could possibly be. Megasquirt PnP Miata 99-00 Matt- I believe I created my own map that I'm sure was hideously incorrect. But I did scale the injectors as 1845..4..700..14.7 and came out with 4.4. After going back to the map provided and scaling the injectors it still wouldn't start. I didn't work with the timing because the instructions say to do that once the car is started. |
Back at this again. After attempting to load the tune provided I get this:
9 Warnings: Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:flexport equal to the proposed "JS11" Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:spk_config_spka equal to the proposed "JS10" Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:rtbaroport equal to the proposed "MS2 AD6/JS5" Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:ego2port equal to the proposed "MS2 AD6/JS5" Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:boost_ctl_pins equal to the proposed "JS11" Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:tacho_opt3f equal to the proposed "D14" Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:launch_opt_pins equal to the proposed "PE0/JS7" Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:N2Oopt_pins2 equal to the proposed "IAC1+2" Warning: Parameter in .msq, but not valid for current firmware: No options found for Bit EcuParameter:N2Oopt_pins equal to the proposed "PE0/JS7" What am I missing here? Is there anyway to start fresh? |
Just give those settings a sanity check - the 3.3.0 code renamed some of the I/O ports.
|
All times are GMT -4. The time now is 12:09 AM. |
© 2024 MH Sub I, LLC dba Internet Brands