need help with megasquirt rpm mismatch
07-21-2017, 05:39 PM
#1
Newb
Thread Starter
Join Date: May 2017
Posts: 3
Total Cats: 0
need help with megasquirt rpm mismatch
hello everyone,
i am in serious need of help, i have failed to find a solution to this,
i build a MS2 v3 from diy autotune, used this guide start to end
"http://miataturbo.wikidot.com/ms2-a"
loaded up the 90-93 miata basemap,
the car wont start if the ignition is inverted,
if its normal it starts but does not idle, and RPM in tuner studio is way higher then that on my tach
on my tach its showing below 1k, and i can feel is dying out, as its just below what my car normally idles at,
on TS is over 2k.
not for my setup,
1990 mazda eunos 1.6
i am using a LC2 wideband,
gm IAT, and thats it for the mods really, its a completely stock car besides an exhaust.
i am in serious need of help, i have failed to find a solution to this,
i build a MS2 v3 from diy autotune, used this guide start to end
"http://miataturbo.wikidot.com/ms2-a"
loaded up the 90-93 miata basemap,
the car wont start if the ignition is inverted,
if its normal it starts but does not idle, and RPM in tuner studio is way higher then that on my tach
on my tach its showing below 1k, and i can feel is dying out, as its just below what my car normally idles at,
on TS is over 2k.
not for my setup,
1990 mazda eunos 1.6
i am using a LC2 wideband,
gm IAT, and thats it for the mods really, its a completely stock car besides an exhaust.
Reply
0
0
