Readings from LC1
If I've installed everything and calibrated correctly, what should I see on the AFR gauge in the Tuner Studio panel at idle? It should pretty much be steady at around whatever AFR is in the table, correct?
I seem to be way rich and the needle sort of stutters. Jon |
you wont see the afr targets in the table untill you adjust the fuel table so that you hit that target.
|
I don't quite understand that.
I have the AF gauge added to the virtual instrument cluster and am reading off of that. I'd expect it to match roughly what is in the AFR target table. I can look at both the forced target table and the VEAnalyze Live AFR table to see the target. I don't think the LC1 is giving the correct readings as using VEAL was making it run worse and completely different from what I was getting with the stock 02 sensor. The table was altered pretty drastically. I'm going to try calibrating again, as I might not have let the sensor warm up long enough. |
my LC-1 sometimes decides to output weird numbers that make no sense for conditions or sweeps from 12:1 to 16:1 at idle with o2 corrections on (target table is 14.0:1) and set down to 500rpm... try cycling the key a few times...it sometimes fixes it for me
|
I'll give it a shot. Thnx
|
I didn't know you couldn't calibrate with a PC attached, or that you had to off/on the car to get the LC1 out of programming mode. Why this isn't in the manual, I don't know. Working great now!
|
All times are GMT -4. The time now is 01:32 PM. |
© 2024 MH Sub I, LLC dba Internet Brands