Reverant, 1.3.0 FW?
As my car has been down for TURBO, I have not yet moved the MS3 from 1.2.3 to 1.2.4 firmware.
Now 1.3.0 is out. Should I jump on up to that? |
I haven't tried it yet, so I can't comment.
|
FWIW it works fine on my car.
You'll loose some idle settings though so will have to manually input them. You'll have have to re-tune the PID idle settings, and position the 'slider' appropriately. |
Thanks. After I have car running again, I'll try it out.
|
I just upgraded to the 1.3 on my rev built ms3. Using a fm 36-2 wheel and it's working flawlessly.
|
Originally Posted by ryanr
(Post 1115173)
I just upgraded to the 1.3 on my rev built ms3. Using a fm 36-2 wheel and it's working flawlessly.
|
Fm 36-2 wheel with stock nb crank and cam sensors. Just used 36-2 miata at the bottom of the list in the ignition options. Fired right up on the first try.
And as of a couple days ago I am now running it full sequential ignition with ls2 coils. Idles smoother than stock. |
Originally Posted by Ben
(Post 1115898)
Awesome. Are you using the 36-2 decoder with an NB cam sync, or did you set it up as a missing tooth wheel without cam sync (or single tooth cam sync)?
Originally Posted by ryanr
(Post 1115937)
Fm 36-2 wheel with stock nb crank and cam sensors. Just used 36-2 miata at the bottom of the list in the ignition options. Fired right up on the first try.
And as of a couple days ago I am now running it full sequential ignition with ls2 coils. Idles smoother than stock. |
Mine is running flawlessly with vvt. Once I got all the pid settings dialed in vvt control is rock solid with the 36-2 wheel.
|
Originally Posted by shuiend
(Post 1115945)
Ben, I know you guys were testing an alternative trigger wheel at DIY. Was it the FM 36-2? If so do you know if they got it working with VVT? It is awesome to hear that it is running perfect with sequential fuel and spark.
|
Why would you want to go from the stock sensors to the 36-2? Only for the increased resolution?
|
Originally Posted by WestfieldMX5
(Post 1116945)
Why would you want to go from the stock sensors to the 36-2? Only for the increased resolution?
|
All times are GMT -4. The time now is 07:48 PM. |
© 2024 MH Sub I, LLC dba Internet Brands