Reverant Ms2 Enhanced
 

Hi all. Im looking for some information on Reverant's Ecu's. Does he run his own version of tunerstudio as we were unable to load a normal NA basemap onto the MS2 i have. The MS is fitted in a late MK1 (97, 3 plug ecu) car now. The car wouldn't start though. It would crank and there was fuel but we weren't getting a spark. I do sadly have a list of things I will send to see if you can come up with an idea or two.

The tps was constantly raising
Coolant temp sens was going wild
Afr was searching
The spark table was searching
There was no IAT plugged in
And as I said before, there was fuel, but no spark.

Any suggestions to make the car fire are appriciated.

Many Thanks

I am presuming an MS2 Enhanced. Older versions of MS2E use custom FW. Newer ones use standard FW. I will call him for you, but you will need to have the S/N or Hardware version of the MS2E that you have.

@Reverant

It is an MS2 Enchanced. I don't currently have the Ecu on hand as it is in the car at the garage. I have the serial for that module (10657), or i can get the hardware version tomorrow morning. Unfortunately that's the best I can do for now. I would also ask that if he had a pinout for the ecu, that we could double check that where we have wired into the other car that the ecu is wired in properly.

I've been trying to get a hold of Rev via PM and email also, regarding an MS2E I picked up here for my MSM. I need the Tuner Studio side pre-3.3.2beta.ini to connect. (or a firmware update & basemap?). If you reach him, can you ask him for me too? :) I've sent him serial #, as well as the firmware on the MS and file that TS is looking for.

This ECU will only work on a 99-00 NB. It's very likely that you have damaged the ECU by installing it on a 96-97.

We had changed the loom on the 97 car to suit a 99-00 pinout. We have most of it working but we just aren't getting a spark/the car won't run.