Reverant Ms2 Enhanced
#1
Reverant Ms2 Enhanced
Hi all. Im looking for some information on Reverant's Ecu's. Does he run his own version of tunerstudio as we were unable to load a normal NA basemap onto the MS2 i have. The MS is fitted in a late MK1 (97, 3 plug ecu) car now. The car wouldn't start though. It would crank and there was fuel but we weren't getting a spark. I do sadly have a list of things I will send to see if you can come up with an idea or two.
The tps was constantly raising
Coolant temp sens was going wild
Afr was searching
The spark table was searching
There was no IAT plugged in
And as I said before, there was fuel, but no spark.
Any suggestions to make the car fire are appriciated.
Many Thanks
The tps was constantly raising
Coolant temp sens was going wild
Afr was searching
The spark table was searching
There was no IAT plugged in
And as I said before, there was fuel, but no spark.
Any suggestions to make the car fire are appriciated.
Many Thanks
#2
Retired Mech Design Engr
iTrader: (3)
Join Date: Jan 2013
Location: Seneca, SC
Posts: 5,009
Total Cats: 856
I am presuming an MS2 Enhanced. Older versions of MS2E use custom FW. Newer ones use standard FW. I will call him for you, but you will need to have the S/N or Hardware version of the MS2E that you have.
@Reverant
@Reverant
#3
It is an MS2 Enchanced. I don't currently have the Ecu on hand as it is in the car at the garage. I have the serial for that module (10657), or i can get the hardware version tomorrow morning. Unfortunately that's the best I can do for now. I would also ask that if he had a pinout for the ecu, that we could double check that where we have wired into the other car that the ecu is wired in properly.
Last edited by Samk1Mx5; 04-23-2017 at 01:42 PM.
#4
I am presuming an MS2 Enhanced. Older versions of MS2E use custom FW. Newer ones use standard FW. I will call him for you, but you will need to have the S/N or Hardware version of the MS2E that you have.
@Reverant
@Reverant