seriously fed up...someone help!
 

right went out today aftyer running tunerstudio and its running liek a sack of shit again.

im seriously fed up with this.

i dont know what to do, everytime i change something somethign else fucks up.

excuse the french but im seriously ticked off now.

iv spent 5 months rebuilding the whole bloody car and i cant get it to run right.

please can someone advice.

holding revs is terribel especially below 3000 rpm it splutters and splatters and judders around.

there a several points throughout the rev range where it does the same.

iv tuned the map on tunerstudio but im not getting anywere im going one step forward 2 steps back

would an msq help? if so please can someone talk me through how to do it.

What megasquirt? what year car?... what wideband, etc. These things should be in your sig, or at least in your post.

sorry,

1990 mk1 1.6
ms2, 440 cc injectors with dropping resistors
innovate lc1 wideband
begi turbo, intercooler, bov

Post your msq and a log of your problems.

ok ill get one up tomorrow

watch this space please

right finaly got a data log

hope it is what you need to help me.

Download 2011-04-28_14.10.59.msl from FileFactory.com

Can you post your MSQ as well? It would be useful to see what your settings are currently at.

Why did you upload that using that shit service? Just attach it to the post... took me 2 minutes to even start the download, and even then I was worried I'd click some bs advertisement. :vash:

Ok from the mess of a log- Your fuel is a complete mess. Where did you get your map?

At around 47kpa and 3000 rpm you have just about zero fuel. This will cause the "splutters and splatters and judders around".

Are you using the AFR Target table? If so, it's telling the car to go lean. The target table is a mess. Disable it until you've worked out your fuel. There are other issues though. Just upload your MSQ file.

thanks buddy,

i realy appreciate it,

where do i find my msq file?

Hoy shit Dave, what've you done to your map?!?

the .msq is the tune, file>save tune as.

tell me about it,

it was running perfectly i have no idea what iv done.

heres the msq

by the sounds of it youd be best to read up and do it yourself and deal with the learning curve rather than ask here and do a few things because your told to and get a car that runs not great and still dont know how to fix that.

Dann

True story. The little important info you pick up here and now might help but you will have no idea why it helped. Do some reading. The MS manual is great!

i respecxt that reading and learning would be ideal, but this is my daily runner, hence why im posted for help quickly.

if you wouldnt mind spending some time and telling me what to do i would appreciate it.

Put the stock computer back in, wire wastegate open, dont boost, lrn2mgasqt?

Dann

Your VE and spark tables need to be completely redone. I'd recommend taking it to a shop with a chassis dyno (rolling road), preferably a steady state version, and have them dial in those tables. Sure, it is a bit price, but four hours of dyno time can save you four months of frustration.