2am and MS or car is not working.... so close...
#1
Miotta FTW!
Thread Starter
iTrader: (24)
Join Date: Jun 2006
Location: Chicagoland, IL
Posts: 4,290
Total Cats: 31
2am and MS or car is not working.... so close...
It's almost 2am... trying to get miata started after firefighting other build issues..
No spark, no fuel. MS when hooked into laptop shows accurate sensor readings. I've tried AL's map and Akayreyre's map.
Ignitor gets warm, but not 'hot'/untouchable.
Where are the major grounds?
I found two in the IM side harness... they goto motor or chassis?
No spark, no fuel. MS when hooked into laptop shows accurate sensor readings. I've tried AL's map and Akayreyre's map.
Ignitor gets warm, but not 'hot'/untouchable.
Where are the major grounds?
I found two in the IM side harness... they goto motor or chassis?
#4
Supporting Vendor
iTrader: (5)
Join Date: Jun 2006
Location: Duluth, GA 30097
Posts: 803
Total Cats: 0
Did we do the 'Miata Mods' to it as well? (Sure I could look up the order, but not under your board name )
What stim version are you using? If it's 2.1 or 2.1, is it modded with the 200ohm R4?
A 2.1/2.2 Stim with the standard R4 will not trigger a 'Miata Modded' ECU, you shouldn't get a tach signal. You can tell if your stim is modded quickly as R4 will be bigger than the other resistors.
What stim version are you using? If it's 2.1 or 2.1, is it modded with the 200ohm R4?
A 2.1/2.2 Stim with the standard R4 will not trigger a 'Miata Modded' ECU, you shouldn't get a tach signal. You can tell if your stim is modded quickly as R4 will be bigger than the other resistors.
__________________
Jerry a.k.a. 'FoundSoul'
DIYAutoTune.com
'91 Miata BEGi S3 GT2560 w/ MSPNP - 14.1psi - 253whp, 232wtq
'95 Miata n/a
A few other cars....
Jerry a.k.a. 'FoundSoul'
DIYAutoTune.com
'91 Miata BEGi S3 GT2560 w/ MSPNP - 14.1psi - 253whp, 232wtq
'95 Miata n/a
A few other cars....
#5
Miotta FTW!
Thread Starter
iTrader: (24)
Join Date: Jun 2006
Location: Chicagoland, IL
Posts: 4,290
Total Cats: 31
No, I mean it was modded with your mods. Not built by you guys.
Stim v2
With "stim for wheel" I'd get rpm and it would work nicely on the computer....
I wired it up per my "check my harness" thread.
I wired up my Innovate LC-1 into the car side of the harness.
-used 1b for power, and 2A for blue gound, 2C for other 2 smaller grounds
I also ran my GM IAT to the ecu
-1 to sensor location and other to 2C ground
I'm getting no spark and no fuel. Fuel pump primes... car turns over (starter). But no catching at all. When I plug laptop into ECU, it shows sensors reading real data.
Stim v2
With "stim for wheel" I'd get rpm and it would work nicely on the computer....
I wired it up per my "check my harness" thread.
I wired up my Innovate LC-1 into the car side of the harness.
-used 1b for power, and 2A for blue gound, 2C for other 2 smaller grounds
I also ran my GM IAT to the ecu
-1 to sensor location and other to 2C ground
I'm getting no spark and no fuel. Fuel pump primes... car turns over (starter). But no catching at all. When I plug laptop into ECU, it shows sensors reading real data.
#6
Do you see rpm on megatune when youre cranking?
It was very helpful for me to diagnose wrong polarity on my vr sensor wiring. In your case it would tell you if your ignition or cas wiring is correct.
Are your coils wired correctly? if youre getting rpm on megatune and not catching, it could be that your spark plug wires need to be switched. One problem when I was starting mine was I had crossed the ignition coil wires. it was firing the wrong coil which in turn was messing up the ignition firing order. HTH
It was very helpful for me to diagnose wrong polarity on my vr sensor wiring. In your case it would tell you if your ignition or cas wiring is correct.
Are your coils wired correctly? if youre getting rpm on megatune and not catching, it could be that your spark plug wires need to be switched. One problem when I was starting mine was I had crossed the ignition coil wires. it was firing the wrong coil which in turn was messing up the ignition firing order. HTH
Thread
Thread Starter
Forum
Replies
Last Post
Jike Spingleton
Cars for sale/trade
3
09-20-2016 04:33 PM