Trouble getting car to start on diypnp
 

I recently finished my diypnp build and got it connected to the car. And can't get the car started. RPMs don't show up on dash or in tunerstudio. Also nothing shows up when i do a composite log. It shows empty read. Nothing shows in tooth, trigger, or sync loss logs either.

Attached my current tune, but i dont think that my tune would cause cam or crank signals to show up. I do have the 470k ohm pull ups installed. And also installed the gm iat sensor and disconnected MAF.

On a side note the car worked just fine with AEM FIC installed and I did removed all the related hardware.

I was finally able to get a composite log. Crank signals look great but cam signals still won't join the party.