Tunerstudio Doesn't See The Lambda Sensor
Okay, strange issue.
My DIYPNP MS2/Tunerstudio sees my OEM Lambda sensor okay, now swapped it out for my LC-1. Setup my LC-1 correctly, wired into the 15DB socket then across to the O2 input on the mainboard, Tuner Stuido doesn't see it. I have set tunerstudio to use the LC-1 default in the project properties and as a single wideband in the EGO settings, BUT the TS dashboard gauge sits at 10.1 AF ratio. Soooo, got a multimeter and tested the voltage from the LC-1 brown wire in the 15DB plug and at the O2 input on the mainboard and I am seeing around 2.2-2.6 volts at idle (bare in mind it isn't tuned yet). So the mainboard is seeing the correct voltage, any suggestions? Have I missed a setting in tuner studio somewhere? |
Posted this on Nutz too, but you need to calibrate the AFR table in Tools>Calibrate AFR table too.
Do this and it'll work. |
:bowrofl:
knew it was something easy thanks |
All times are GMT -4. The time now is 11:48 AM. |
© 2024 MH Sub I, LLC dba Internet Brands