Tunerstudio Doesn't See The Lambda Sensor
#1
Tunerstudio Doesn't See The Lambda Sensor
Okay, strange issue.
My DIYPNP MS2/Tunerstudio sees my OEM Lambda sensor okay, now swapped it out for my LC-1.
Setup my LC-1 correctly, wired into the 15DB socket then across to the O2 input on the mainboard, Tuner Stuido doesn't see it.
I have set tunerstudio to use the LC-1 default in the project properties and as a single wideband in the EGO settings, BUT the TS dashboard gauge sits at 10.1 AF ratio.
Soooo, got a multimeter and tested the voltage from the LC-1 brown wire in the 15DB plug and at the O2 input on the mainboard and I am seeing around 2.2-2.6 volts at idle (bare in mind it isn't tuned yet). So the mainboard is seeing the correct voltage, any suggestions?
Have I missed a setting in tuner studio somewhere?
My DIYPNP MS2/Tunerstudio sees my OEM Lambda sensor okay, now swapped it out for my LC-1.
Setup my LC-1 correctly, wired into the 15DB socket then across to the O2 input on the mainboard, Tuner Stuido doesn't see it.
I have set tunerstudio to use the LC-1 default in the project properties and as a single wideband in the EGO settings, BUT the TS dashboard gauge sits at 10.1 AF ratio.
Soooo, got a multimeter and tested the voltage from the LC-1 brown wire in the 15DB plug and at the O2 input on the mainboard and I am seeing around 2.2-2.6 volts at idle (bare in mind it isn't tuned yet). So the mainboard is seeing the correct voltage, any suggestions?
Have I missed a setting in tuner studio somewhere?
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM