I bought a set of id1000's if a fully built BP with a Compturbo ct4-6062. I am using a MS1 extra running the hi res code. How hard is it to configure my current setup to get it to run with these injectors. I am at 18psi and am maxing out my 620cc injectors if I go any higher. I am wanting to get up to between 24-26psi hence the new injectors. Any help would be appreciated.

Jeff

 

Should work fine. I'm running dw800's, and while they aren't quite as big they are actually a older less responsive injector than the ID's. I still got mine to idle perfectly @14's afr on my MS1 w/ hi-rez.

Or are you asking exactly what to do step-by-step to get these running? If that is your question, you best search around because nobody will spoon feed you that. It's really easy though.

Good luck!

 

I've done it before. Its not going to be perfect, and you'll have to run em fat like fireindc says (14 or so afr) but its do-able.

 

I think you just scale your req fuel for the change and adjust the deadtimes.

 

If 14 is a fat idle, mine is gluttonous. I'm around 12.8-13.

 

Mine is 14's when it's first started up, and warmed up to operating temp - but after a good flogging something must be off with my temp enticements, because it goes to a mid 12. Ahh, so much to learn. The glory of having an EMS more capable than its tuner.

 

Ha, I agree!

Mine is sitting at 12.8 - 13 as well. Haven't got to fine tuning the idle afr's yet.