Heya,

I've been running the Honda 11.44" rotors on the rear for a season and I'm due to replace my rotors. I noticed in a post you mentioned you're getting custom made ones through Coleman Racing. Are they remakes of the standard Wilwood ones? Any more info as I'd be interested in 4 replacement rotors.

Cheers,
Rick

I don't but its all the same as a Miata 6 speed except 4th gear.

Hi,

do you have the countershaft and main shaft gear teeth count for the rx8 gearbox handy ?
I have seen the s15 and mx5 6 speed gear teeth count in one of the posts but couldn't find the rx8 one...

Thanks in advanced..

I don't know much more about the details of the mix match between the boxes seems like the s15 shifter is maybe an inch or two further forward than the Miata.

HI,
Do you have anymore info on the 6 speed aisin boxes regarding extension housing changeability between the rx8, mx5 and s15.
As I am trying to fit an rx8 box into an older rx7 , we tried an mx5 extension housing but the shifter is too far back , rx8 is too far forward but I do not have any info on the s15 ex housing as this one sits in between and would be nearest to the factory 5 speed shifter

Any info would be great..
Thanks
Michael...

Hi,
I have a NB Miata that was a XP car that was being converted to DP. I'm think XP for my rebuild of it. I'd love to see detailed photos of the semi tubed front section you posted.
Jim in NM

Are your rc750's still for sale?

Hi Bob,

I just got my first Miata and would like to start looking at turbo and supercharger kits. Can you share some of the details about your setup? I see you've put a 2.0 in yours.

Thanks!
-- Scott
(former Ultima GTR owner)

Hi Bob. i ran across the cfd thread on m.n. http://forum.miata.net/vb/showthread...=266820&page=5
I am quite curious about doing a little aero modeling of the front of the car. I was wondering if a workable model exists for NAs.
thank u sir

It is the Universal fit GTC200 wing with two sets of Universal fit GTC200 2.5” risers. I made my own small brackets to mount it to the fender in the trunk lid gap which are made from1.5” X 1.5” X 1/8” thick aluminum angle. Hacksaw and a drill did the trick.

Bob