This works as a pnp for a 01-05 miata. It ran my boosted car well for a year with no issues. I have a few jumpers soldered in, one for the vehicle speed sensor to work well enough for boost by gear- it works but the signal is too noisy for anything other than that.
Has the bluetooth module so you can tune and log over bluetooth, no cable needed.

These get an overly bad rap, if you just want something to learn and run your car, this will do that and more.

I have boost and flex pins soldered in and wired outside the board to easily access. I personally used the flex pin.

It has an stm32 adapter board with epicefi firmware on it (rusefi based) this firmware is very good. I had my car idling insanely well on it, with arguably better/more features than megasquirt. It also is still getting live support and updates, with its own tuning software released and being developed. The adapter board also has sd card logging and an mcu that is miles faster than the ardunio board. - the board has a tune and pinouts on it that fire up the car and works, it needs to be tuned like any other standalone. You will need a 36-2 trigger wheel for it to work smoothly above 4k rpm. I have a 36-2 on the way, but i also got an ms3 for an insane deal, which i opted to just throw in and tune instead.






The speedy case has a custom 3d printed endcap that uses the stock mounting bracket to bolt up into the oem location. No zipties needed. will ship on buyers expense and trust. 79416


$350 obo

 

bump 300$ + shipping