1990 turbo miata PARTOUT
4 Attachment(s)
But the car complete for $6500...or....
1.6l Built engine 337hp to the wheels on e85. Millenium Motorsports Built engine (Rebuilt stock head ARP head studs Manley rods supertech pistons boundary oil pump ACL Race bearings) (2500 miles on the engine).....PENDING Begi intake manifold...PENDING Artech Manifold and downpipe Rebuilt 15g with a 19t cold side with oil lines, intercooler and piping (2500 miles on turbo)...SOLD Flyin Miata "Happy meal" clutch and lightweight flywheel....PENDING 3.9:1 torsen diff with housing axles and drive shaft.....800 Megasquirt Ms3x ecu with knock module and sensor, mapdaddy map sensor with second map,internal bluetooth, relayboard with cable, both diyautotune pigtails for the main and expansion boards.....SOLD IGN-1 coil per plug (4 coils and igniters)....225 Flyin Miata BIG FUEL kit with fuel rail....400 Fiveomotorsports "black-ops" 1200cc injectors....PENDING Ron Davis Racing radiator....SOLD Momo steering wheel w/Dakei adapter....150 Bilstien Revalved shocks with ground control coilovers and eibach springs and ISC tophats......SOLD Racing beat front and rear swaybars....100 |
Interested in the FM happy meal
Can you PM me since I cannot PM you due to post count |
Have any other info on the ms3x? Did you just run timing off the CAS or did you also use a trigger wheel for your build?
|
Ms3x was running full sequential fuel and ignition, with knock, boost control, oil pressure input, table switch.......timing was run off of the cas.
|
**stupid question is stupid question**
I am interested in the intake, what throttle bodies are available and why would I want this manifold over a Honda manifold? |
I was running the stock 1.6l tb. Setup made over 330whp. This manifold is from Begi, it books up to the head......as far as I know the Honda intake manifold requires some serious modification.
|
Hi Toby,
Where are you located? |
Orange county, ca
|
Can u pm me a number, I can't pm you back
|
Pm'd.
|
I'll take these, what are the spring rates and lengths on the Eibachs?
"Bilstien Revalved shocks with ground control coilovers and eibach springs and ISC tophats......650" |
Originally Posted by tottestad
(Post 1039794)
I was running the stock 1.6l tb. Setup made over 330whp. This manifold is from Begi, it books up to the head......as far as I know the Honda intake manifold requires some serious modification.
|
Np
|
Is the radiator still available? Can you send me an email to sugup@bellsouth.net with condition and if it will fit a 97?
I don't have enough posts to pm. Thanks. |
Radiator sold
Ms3x sold |
DANG a few hours too late, I wanted that ECU!
|
What type of adapter on the momo?
|
Sale pending on the whole car....
|
Sale didn't go through....buyer couldn't sell his car to pay for mine...
|
Tried to PM but your box is full.
|
All times are GMT -4. The time now is 01:58 PM. |
© 2024 MH Sub I, LLC dba Internet Brands