Cspence's MASSIVE Part Out - AEM Tuckin99 T25 Koni H&R Flyin Miata Tial
 

Well after a year of trying to sell the car and not being able to get rid of it as a whole, now I must part it out entirely :facepalm: I made a quick list of the bigger items I have, but theres many things I did not list. For those, please pm or email with any special requests. As always, local pickup would be preferred, but I'll ship at your expense (on most things, ie - I'm not shipping the hood, exhaust, etc) Also, I've done a far amount of research and I feel that the prices I have listed are more than fair, so please don't waste my time or yours with low ball offers. If your interested in multiple items, I can work with you and combine shipping... And on that note, lets get this thing going! ;)

**Pictures added**
PM or Email (Email may be better since my PM inbox always fills up quickly) with questions and offers (SpenceChristopher@yahoo.com)

AEM Uego SOLD! $100

AEM Tru Boost SOLD! $150

Tuckin99 Flares (Real not Copies) SOLD! $500

Top Hats SOLD! $200

Koni Yellow Coilovers & H&R springs SOLD! $600

LSD Rear End w/ Delrin Mounts WITH AXLES (1.8 rear with rx7 clutch packs) $500

1.8L Tranny (Grinds a little on 1 - 2 shifts if driving spiritedly, otherwise its fine) $250

Turbo Parts (Custom exhaust manifold, Tial WG w/ 7psi & 10psi springs, T25 ChinaCharger, Custom 3" SS DP, gaskets & hardware, AN line for oil return, stainless oil feed line with block fitting and turbo fitting) UNDER DEPOSIT! $800

Intercooler w/ 2.5" SS piping, silicone couplings, t-bolt clamps 24"x6"x3" bar and plate type with custom end tanks SOLD! $250

Custom Intake Manifold w/ support and stock fuel rail UNDER DEPOSIT! $250

Engine (Longblock, no clutch or accessories, has arp hardware, flyin miata head gasket, rebuilt about 15k ago) SOLD! $500

Clutch (Flyin Miata ACT, Street Disk / Extreme Pressure Plate) SOLD! $200

Wheel Spacers (Motorsport Tech) 30mm - 2.8#s and 19mm - 2.05#s with the adapter nuts (Includes custom install tool and acorn nuts)$250

Hood (Stock aluminum polished with Z34 Vent and molded barn doors, not astetically perfect) $200

Exhaust - 3" Straight , Hi Flow Magnaflow Cat & Magnaflow Res, no muffler $150

Chassis (Once its all stripped) $FREE FREE FREE FREE FREE or its getting hacked up

Injectors (RC 440 Low Impedance) UNDER DEPOSIT! $200

MegaSquirt V2.2 UNDER DEPOSIT! $250

Guage Panel (Custom Cspence Special :giggle:) $40 or $75 including the center console to dash trim piece

Gauge Hood SOLD! $50

Stock Guage Cluster $30

Center Console $30

Triangle Windows $25

Drop in Windows $50

Gutted Doors (Easy way to drop some weight, still have mounting spots for speakers) $50

Door Panels $50

Drivers and Passenger Seats GONE! $Come get them

Dash Cover (No cracks and have title to match) SOLD! $75

Steering Wheel with hub SOLD! $30

Custom aluminum Oil Catch Can with stainless AN lines and K&N breathers SOLD! $50

Polished Valve Cover (Cams exposed and AN fitting for catch can) SOLD! $75

Weapon R Coolant Catch can SOLD! $25

Radiator w/ fan(Custom Aluminum) 24"x19"x3" $150

Flyin Miata Sway Bar $75

Stock Rear Sway Bar $Free

Adjustable End Links Front SOLD! $30

Adjustable End Links Rear SOLD! $30

Control arms with Poly Bushings (**Ball joints need to be replaced, noticed upon removal** )SOLD! $300 ($150 for fronts / $150 for rears)

1.8L Brake Setup, rotors, calipers, brackets, ebc red pads, stainless braided lines $300

Walbro 190 UNDER DEPOSIT! $50

Greddy RS BOV (replica) SOLD! $40

1.6L Ignition Coil $50

Ignitor $20

Plug Wires $20

Smoked Stock Tail Lights $50

Sheet Metal Frame Rails w/ Hardware $75

Custom Sheetmetal headlight scoop SOLD! $25

Custom Sheetmetal Bumper scoop SOLD! $25

Front Bumper GONE! $free with your purchase of 200 or more

Steering Rack with tie rods SOLD! $50

Clutch Master Cylinder and Slave Cylinder (Both replaced earlier this year) SOLD! $25

Brake Master Cylinder and Booster $50

1.8L Drive Shaft $50 OBO

Rear Bumper $Free with a purchase of 50 or more, lol

Rear Finishing panel (No cracks) $40

R Lip Spoiler for Trunk SOLD! $40

Trunk Lid $20

Starter SOLD! $20

Alternator with bracket and mounting hardware SOLD! $20









DRUM ROLL PLEASE! :giggle:

Attachment 186908

Attachment 186909

Attachment 186910

https://www.miataturbo.net/attachmen...ine=1317506875

http://i389.photobucket.com/albums/o...g?t=1267486353

Attachment 186911

https://www.miataturbo.net/attachmen...ine=1317506761

https://www.miataturbo.net/attachmen...ine=1317506761

https://www.miataturbo.net/attachmen...ine=1317506761

https://www.miataturbo.net/attachmen...ine=1317506761

http://i96.photobucket.com/albums/l1...2/CIMG2240.jpg

Attachment 186912

Attachment 186913

Attachment 186914

Attachment 186915

Attachment 186916

Attachment 186917

Attachment 186918

Attachment 186919

Attachment 186920

Attachment 186921

Attachment 186922

Attachment 186923

Attachment 186924

Attachment 186925

Attachment 186926

email'd ;)

I forget if it was a 1.8 or 1.6

Soo many things......soo tempting.......

Sorry to see its come to this man.

I'm sure you'll have no problem moving all the parts individually though.

It a 1.6, but the drive line and brakes are from a 1.8

is there anything wrong with the engine? also was it rebuilt to oem specs or with other parts? Btw might be able to pick it up tomorrow if I can get my dad's truck for the afternoon.

Nothings wrong with the engine...I was out boostin around up until two weeks ago when the wheels sold....

However, I won't be ready that quickly lol. I have a TON of stuff to take off

ill take the wideband when can i come pick it up

sounds good man, I'm going to PM you my contact info

now! I just took it off the car a few hours ago...

Email sent.

replied

I'll take the gauge hood assuming no cracks. Tired of watching mine bounce back and fourth every time I launch.

No cracks, but just as a disclosure, the clips are epoxied on....I didn't even know this until I pulled it tonight because someone had emailed me about it.

emailed re: diff, sway bar, endlinks, frame rails.

Replied....If things dont end up selling I'll see about shipping overseas. Thanks!

Emailed re: coilovers & A-arms

DAMN!! thats fair enough though.
I am pretty keen on all of the stuff mentioned and have the money ready to go if you do change your mind!

Fr. Upper control arms & rear adj. End links.
 

I,ll buy those. Unless those are already gone.
Ship to 33050?

Can you email me at d.jtc@hotmail.com I'm interested in a few parts just dont have the post count to pm.