F/S Direct Port Nitrous
 

:cry: This is hard. Really hard. I have, for sale, my Edelbrock Performer Series direct port nitrous system. Complete with over 100 dollars worth of lines, fittings, fuel pressure gauge, and adapters not included with the kit when purchased, but were necessary for its installation. This is Edelbrock's high end direct port system. It is currently jetted for a 100 shot, but will include 40 jets total to change to a 50, 75, 100, 150, and 200 shot. This is the performer series which means Stainless Steel everything. SS jets, SS lines, SS foggers (Upgraded to E2 foggers for better atomization), larger solenoids for better flow, etc. This was the best of the best when I bought it less than two years ago for 500 bucks. I then added over 100 dollars worth of fittings, lines, etc to make it work on my miata. All the hard lines are already made so all you would have to do to install this is drill and tap 4 holes in your intake manifold 1/16 NPT and screw in the foggers. I will also include a micro switch with a custom bracket that will bolt up below the gas pedal so the nitrous only comes on when you floor it. This is as close as you'll ever get to plug and play direct port for a miata.

I have 600 plus shipping plus many many hours of time in the above parts. All were purchased new and are in like new condition. I'll sell all that for $400 shipped.

I also have a Cold Fusion Progressive Controller. I paid 220 for it new plus shipping. I'll sell it for 120 shipped. Nice to have when I sprayed a 100 shot so I could ramp the shot in first gear to plant the rear end and keep from spinning. Shot digitally adjustable in 1% increments. You can specify the starting percent withing 1% and specify the ramp time to full shot. So say comes on at a 50 shot and ramps to a 100 shot in .4 seconds. That way the rear plants well and you don't get wheel spin. It will also do "continue the countdown" So say you are running a big shot, you can start at say 50 shot and ramp to a 150 in 5 seconds. You start in first gear and spray from a 50 shot to... 93 shot, then when you grab second and floor it, the controller automatically picks up where it left off and continues the countdown to your specified maximum shot.

I also have a MSD Dual Stage Window switch. (allows you to specify when it comes on AND off, not just on only) I paid 120 shipped for it new. I'll sell it for 70 shipped. With this one you can specify say 3900 RPM on and 7000 off. Could also be used to trigger VICS solenoid. Digitally adjustable in 100RPM increments.

Or, if you buy the direct port, I'll let the controller go for 100 and the window switch for 60.

Add a bottle and feed line to the above and you are spraying.

This would be great for anyone looking for cheap power now, spooling a large turbo, or icing on the cake on their built turbocharged beast.

All prices are FIRM. Don't even ASK.

Will post pics shortly.

Very interested!!! Pictures please

First pics are when I first installed the nitrous. Later pics are pics I just took with it off the car. I have many more pics, but I never uploaded them to photobucket. If someone is serious about buying it and wants more pics I have more.


Attachment 211288

Attachment 211289


Look carefully you can see the distribution block.
Attachment 211290

Removed the intake manifold. Last pics of the system installed.

Attachment 211291

Attachment 211292


And removed from the manifold. This is how it sits now.
Attachment 211293

Attachment 211294

Attachment 211295

Attachment 211296

Attachment 211297

I know only the basics about nitrous, so excuse me if this is dumb, but is there any way this can be integrated to work with MS?

Yes, it could be integrated with MS in more ways than 1. You can let MS turn the nitrous on and off instead of the window switch. Or, you could set this up as direct port DRY shot (simply don't hook fuel up), and let MS add the correct amount of fuel through your injectors (assuming your injectors are big enough to handle it). However, MS can't control the nitrous progressively. That's why I bought the electronics I have. I wanted the control. A straight 100 shot with no ramp time pretty much can't be used in first, and it's a little wild in second.

Still available. Also, I would be interested in trading or trade plus cash for a good t3/t4 turbo, manifold, wastegate, BOV, silicone couplers and bends, etc. Let me know what you have and we can work something out.

I'd take you up on this if my car did not need 10000000000000 more important things right now. Looks like a great deal.

Yeah I know what you mean. It is a great deal as I have a lot of time and money tied up in it and it's in mint condition. Sending you a PM.

375 shipped. Still open to trade for turbo stuff.

Wow good deal, I wish you had this for sale when I still had money!

Out of curiosity, is there a reason for the foam/rubber on the hard lines?

Crap. Thats less than what I paid for my NX wet kit, I looked under the couch, I only found $3.00. damn.

Too bad I don't have a 4 cylinder anymore. Otherwise, I would probably buy it from you.:giggle:

The rubber you see is vacuum tubing. I split it and slid it over the tubes for stealth. The tubes are SS and very shiny. I put black rubber on them and it helped to hide that I had nitrous. I showed my motor to many a people and told them it was stock, and then never saw the nitrous.

Stealth, yeah it's cheap. I hate to let it go.

Mike, add 4 more foggers and you could use it. :)

Sorry Dude, Useless for me.:cool:

Sorry, can a mod delete this one?

Can you set MS up to control the nitrous (on/off @ RAW TP/RPM), while the Progressive Controller controls the shot size?

Yes. That would be letting MS act as the WOT swtich and RPM switch. Would work fine, but you would have to have the fuel added in with the nitrous foggers as MS can not add fuel for nitrous progressively. It can only turn XX size on/off and add the appropriate amount of fuel. MS can do staged nitrous though. But, seeing how MS is open source, if you were a genius you could write your own code and somehow make MS do it. It's possible, but currently not supported.

Oh ok. Thanks. That would be a pretty nice setup I think.

I'm a coder, but not that language =D.

Let's see, I've probably responded to a combined total of 20 PM's, emails, post, etc of "interested" parties. But no buyer.

350 shipped.

I was really intersted until I found out a 10lb bottle would cost me 200 + a line to get it up front. Then found out I would probably need a heater if temperature drops too much below 85.

Then I found out I would have to drive 45 minutes and pay 60 dollars to get it filled every few weeks.

So thats about 700 dollars to start, and 60 dollars plus gas and time to drive and refill bottle as needed.

In case you were wondering why one of those interested parties decided not to become a buyer.

Well, I paid 60 shipped for my 10# used bottle on ebay. But yeah new they're $$$. The feed line's 40' new. I never used a bottle heater. That's kind not necessary MOST of the time. ( if you bracket race then yeah, you need one for consistancy)

And sometimes you have to look around to find places that fill bottles. A lot of medical supply places that sell bottled oxygen can fill nitrous bottles too. And welding supply places that fill various gas bottles have it. And some pawn shops do (two pawn shops here fill bottles). You gotta look around. In a city of 20K population there's 5 places I know of within a 10 minute drive that fill nitrous bottles.

pat dont do it man u can make it. god man that stuff is sweet gl to ya.

325 shipped.

310 shipped.

270 shipped.

How big of a noticeable gain was the 100 shot? I've been thinking about some juice for a little extra.. Kick...

I'd say approximately a 100 HP gain. :giggle: I have the jets to go up to a 200 shot if you get bored with a 100 shot. 100HP is about 1 sec off your 1/4 mile time.

I was asking what kind of seat-of-the-pants feel you could relate.. My 300zx felt absolutely no quicker on 14psi to me than it did on 7psi yet the 7 pound increase in boost netted over 100rwhp. ;) My ass dyno is big time broken.

Wish I had the money right now, I'd buy it. If you still have it in a few weeks and its up for grabs I'll snag it. :D

It made a nice difference. Stock 99' won't outrun a V6 5 speed mustang. I've tried. But with a 100 shot I pull V8 mustangs at any speed. Raced a Z28 on an entrance ramp one day and went around him going about 80mph. Beat a 350Z on the interstate. Hurt his feelings. It's a nice pull. Without the controller, it's just hit of power. Like a you flipped a light switch and pick up 100 HP. With the controller you can use a big shot in first and ramp it for traction. Makes for a good launch.

It will either sell very soon at this price or I'll keep it. I'm not giving it away.

Direct port and window switch sold to dima88. Shipped. Progressive controller is still available, but yeah I doubt that will ever sell here. Off to ebay...

If it makes it to ebay post the link.. i could use a progressive controller but i dont have the money for it right now.