FMII 1.6 Turbo kit, Engine, Transmission, Torsen and much more!!!
#1
Elite Member
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Springfield IL
Posts: 2,712
Total Cats: 25
JDM 1.6 Engine, Transmission, more!!!
Edited to reflect sold/pending parts. New list at bottom!
Let me know if you have any questions! Please refrain from leaving comments. If you do not intend to buy, fill up a thread in the general tech area, not on my thread
Back to the items at hand-
It is a 1991 JDM engine with 55-60k miles on it, 30k on it since the timing belt, water pump, and all the other goodies were added to it.
Package consists of-
FMII Turbo kit with all the options
Link ECU with MAP and Knock sensors, along with an Electronic Boost Controller, and serial link box
RC Injectors
1.6 JDM engine
Vishnu dual feed fuel rail
Flyin Miata clutch kit
108k mile old transmission (I'm assuming it is stock. Engine was only replaced because it was a short nose 1990)
All the PCM wiring harness
Alternator
Pretty much anything 4 cylinder related is going, with an LS1 being swapped in. This would be the perfect little 200+rwhp swap for a Lotus 7
3500 plus actually shipping takes it. It is currently still in the car so you can see it run, and will remain that way until it is sold. It is a blast to drive as is, but the LS1 bug has been biting me for awhile.
I also have a Ron Davis AWR radiator with Dual SPAL fans for sale. The second fan is rarely ever used, and only turns on when you have the AC on in the middle of rush hour traffic.*SALE PENDING*
Torsen rear end swap- Fresh bearings 10k miles ago
Comes with carrier, driveshaft, and axles
*SALE PENDING*
1.8 front brake upgrade with new 949 Big Brake Kit and new Porterfield R4S pads
400 plus actual shipping, or 250 with the purchase of the 1.6 engine. (Making the 1.8 swap pretty much free once you buy the BBK and Pads)
*ADDED*
Vishnu dual feed rail with everything to hook it up to your stock feed rails- 125 plus actual shipping
Alternator- Came on JDM engine- 50 plus shipping?
JDM 1.6 engine- Was told it had 30k miles on it, and has had another 25-30k added since in the car. It had the Timing belt and all other items replaced before going into car (Dealer receipts will be given upon purchase). Pulls 20 inches of vacuum at idle and runs great. Last compression check showed all cylinders to be well within spec and it has ZERO smoke.... Does have lifter tick at the very end of the oil change cycle (change the oil, it goes away for another 2800 miles).- 500 plus actual shipping
109k mile old 1.6 transmission- shifts fine when its not sub 20 degrees out- 150 plus actual shipping
All parts are located in the 62704 area code
Let me know if you have any questions! Please refrain from leaving comments. If you do not intend to buy, fill up a thread in the general tech area, not on my thread
Back to the items at hand-
It is a 1991 JDM engine with 55-60k miles on it, 30k on it since the timing belt, water pump, and all the other goodies were added to it.
Package consists of-
FMII Turbo kit with all the options
Link ECU with MAP and Knock sensors, along with an Electronic Boost Controller, and serial link box
RC Injectors
1.6 JDM engine
Vishnu dual feed fuel rail
Flyin Miata clutch kit
108k mile old transmission (I'm assuming it is stock. Engine was only replaced because it was a short nose 1990)
All the PCM wiring harness
Alternator
Pretty much anything 4 cylinder related is going, with an LS1 being swapped in. This would be the perfect little 200+rwhp swap for a Lotus 7
3500 plus actually shipping takes it. It is currently still in the car so you can see it run, and will remain that way until it is sold. It is a blast to drive as is, but the LS1 bug has been biting me for awhile.
I also have a Ron Davis AWR radiator with Dual SPAL fans for sale. The second fan is rarely ever used, and only turns on when you have the AC on in the middle of rush hour traffic.*SALE PENDING*
Torsen rear end swap- Fresh bearings 10k miles ago
Comes with carrier, driveshaft, and axles
*SALE PENDING*
1.8 front brake upgrade with new 949 Big Brake Kit and new Porterfield R4S pads
400 plus actual shipping, or 250 with the purchase of the 1.6 engine. (Making the 1.8 swap pretty much free once you buy the BBK and Pads)
*ADDED*
Vishnu dual feed rail with everything to hook it up to your stock feed rails- 125 plus actual shipping
Alternator- Came on JDM engine- 50 plus shipping?
JDM 1.6 engine- Was told it had 30k miles on it, and has had another 25-30k added since in the car. It had the Timing belt and all other items replaced before going into car (Dealer receipts will be given upon purchase). Pulls 20 inches of vacuum at idle and runs great. Last compression check showed all cylinders to be well within spec and it has ZERO smoke.... Does have lifter tick at the very end of the oil change cycle (change the oil, it goes away for another 2800 miles).- 500 plus actual shipping
109k mile old 1.6 transmission- shifts fine when its not sub 20 degrees out- 150 plus actual shipping
All parts are located in the 62704 area code
Last edited by chpmnsws6; 12-02-2009 at 06:35 PM.
#2
Elite Member
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Springfield IL
Posts: 2,712
Total Cats: 25
Knocking 500 off the price of the engine/trans/turbo setup
Also, if you just want the kit FM provided, knock 300 off the price, and save a few hundred on shipping. I also have a FM High Flow Cat and FM Exhaust I'll sell with the turbo kit for 300 more.
Also, if you just want the kit FM provided, knock 300 off the price, and save a few hundred on shipping. I also have a FM High Flow Cat and FM Exhaust I'll sell with the turbo kit for 300 more.
#6
Elite Member
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Springfield IL
Posts: 2,712
Total Cats: 25
3600 shipped. I'll eat the rest of the shipping (the last just engine I shipped was 350 to a business) if you can pick up at a service center.
Last edited by chpmnsws6; 11-23-2009 at 08:04 PM.
#7
Elite Member
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Springfield IL
Posts: 2,712
Total Cats: 25
Would you be able to pick it up at a Service Center in Medley FL? It takes about 100 off shipping.
Fedex is quoting around 950 for shipping if using a service center, but they normally hit the 50% mark somehow when I take things in.
Fedex is quoting around 950 for shipping if using a service center, but they normally hit the 50% mark somehow when I take things in.
#10
Elite Member
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Springfield IL
Posts: 2,712
Total Cats: 25
300 shipped within the 48 states takes the AWR Ron Davis Radiator without fans!
700 plus actual shipping on the Torsen differential swap!
Haven't talked to Eljefe305 in a few days to maybe the turbo 1.6 is still up for grabs?
For those worried about feedback, I'm a regular on LS1tech and have a decent amount of feedback. Chpmnsws6 is the Screen name on that site also.
700 plus actual shipping on the Torsen differential swap!
Haven't talked to Eljefe305 in a few days to maybe the turbo 1.6 is still up for grabs?
For those worried about feedback, I'm a regular on LS1tech and have a decent amount of feedback. Chpmnsws6 is the Screen name on that site also.
#11
Elite Member
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Springfield IL
Posts: 2,712
Total Cats: 25
Forgot to add-
Flyin Miata Turbo Single exhaust
Flyin' Miata : Exhaust : Turbo : 1990-97 Flyin` Miata turbo single exhaust
and
Flyin Miata high flow cat
Flyin' Miata : Exhaust : Turbo : FM Catalytic Converter
450 shipped within the 48 states for the combo!
Flyin Miata Turbo Single exhaust
Flyin' Miata : Exhaust : Turbo : 1990-97 Flyin` Miata turbo single exhaust
and
Flyin Miata high flow cat
Flyin' Miata : Exhaust : Turbo : FM Catalytic Converter
450 shipped within the 48 states for the combo!
#14
Did you sell the transmission? If you'll part with it seperately. I'm just south of tampa, fl & could drive to pick up parts shipped somewhere nearby (don't need or especially want them delivered directly to my home).
If the pending sale on the motor/tranny/etcetera does't go through I'd love to jump in a swipe the tranny. Provided you're willing to sell it seperately how much would you ask(shipped near 34207)?
If the pending sale on the motor/tranny/etcetera does't go through I'd love to jump in a swipe the tranny. Provided you're willing to sell it seperately how much would you ask(shipped near 34207)?