Forced Performance Billet 3071R with TiAL turbine housing
Thread Starter
Elite Member
iTrader: (8)
Joined: Dec 2008
Posts: 2,910
Total Cats: 51
From: Kingston, Ontario
Forced Performance Billet 3071R with TiAL turbine housing
$OLD
Selling a great turbo for a Miata.
its a Forced Performance billet wheel turbo based on a 3071R.
Has a stainless TiAL turbine housing (0.82)
The turbo has no thrust shaft play but some radial shaft play. There is no contact of the wheels and housings and I expect it would tighten up with some oil in the chra (its been off the car for a while)
I was going to (and will if it doesn't sell) use this on my car but Im going to go bigger (10mm compressor bigger) with an SXE369 borg warner to make north of 800hp.
$OLD
Selling a great turbo for a Miata.
its a Forced Performance billet wheel turbo based on a 3071R.
Has a stainless TiAL turbine housing (0.82)
The turbo has no thrust shaft play but some radial shaft play. There is no contact of the wheels and housings and I expect it would tighten up with some oil in the chra (its been off the car for a while)
I was going to (and will if it doesn't sell) use this on my car but Im going to go bigger (10mm compressor bigger) with an SXE369 borg warner to make north of 800hp.
$OLD
Last edited by shlammed; Jun 16, 2017 at 08:34 AM.
Reply
0
0
