FS: Custom Intake Mainifold and Momo Wheel with Hub
#1
Elite Member
Thread Starter
iTrader: (18)
Join Date: Dec 2007
Location: oahu
Posts: 1,787
Total Cats: 6
FS: Custom Intake Mainifold and Momo Wheel with Hub
Picked this manifold up a few months back and it doesn't fit because of my engine harness amphenol. It's plenum is 15x4" with 7" runners and trumpets in the plenum, has a 65mm ford throttle body, and an adapter for the 99 and up tps. Fits 99-00 heads. It would fit in a normal car, just doesn't work for me. $400 shipped OBO
Also selling a momo tuner 350mm wheel with hub. Lightly used and one of the holes in the hub needs to be rethreaded (also missing that screw). Comes with everything pictured. $old Shipped
Also selling a momo tuner 350mm wheel with hub. Lightly used and one of the holes in the hub needs to be rethreaded (also missing that screw). Comes with everything pictured. $old Shipped
Last edited by astroboy; 05-15-2014 at 01:30 AM.
#9
Elite Member
Thread Starter
iTrader: (18)
Join Date: Dec 2007
Location: oahu
Posts: 1,787
Total Cats: 6
I think it is. From what I have read guys who go from a stock manifold to a skunk2 Honda manifold it is about 30hp throughout the power band. I wanted to run this Mani but I don't want to chop it up to run it nor do I want to relocate my engine bay amphenol so I am going to build something to fit my bay.
#11
Elite Member
Thread Starter
iTrader: (18)
Join Date: Dec 2007
Location: oahu
Posts: 1,787
Total Cats: 6
I converted my engine harness to amphenol single disconnect and where I put the amphenol through the firewall is where the back of the manifold plenum sits. I don't want to move my harness location nor do I want to chop this up to make it work so I will just sell it and am having a new Mani fabbed. Like I said in the original post it should fit a regular engine bay with no problems.
Thread
Thread Starter
Forum
Replies
Last Post