I have a new chinacharger here, I decided this was too small for what I wanted to do. It's brand new, never installed. However, unlike the one in that listing, mine didn't come with the coolant hardlines for some reason, even though it pictured them in the ad when I bought it. I wouldn't have used them anyway, as most of you probably wouldn't either. It DOES include a weird plate you could use for a downpipe flange on the exhaust housing. Again, came with the turbo, wasn't pictured on the auction.

Goes for $240 new. I'm asking $200 shipped in the lower 48 states.

Same as this turbo: http://www.ebay.com/itm/New-Design-T...item3f0441846f

Specs:

Inlet: 2.5"
Outlet: 2"
Bearing: Wet Floating Bearings (Journal bearing)
Cooling: Oil + Water
Flange: Standard T25/T28Flange
Internal Wastegate: 14psi
Compressor: .42 A/R Compressor
Turbine: .86A/R Turbine
Compressor Wheel: 60mm/42mm
Turbine Wheel: 53mm/46mm

 

Take notes people. When listing a turbo, your ad should look like the above. Specs, links, photos, etc. GLWS, you'll be getting props for the way you listed this. Great example!

 

Also, I forgot to mention this previously, but I am in the market for a Tial MV-S (38mm v-band) external wastegate if someone has one that is slightly used, I would love to trade you for it.

 

Is this equal in size to a 2554 or a 2560?

 

Since it's a chinacharger and the measurements never actually match up directly with Garrett stuff it's not right on either one, but based on comparing the measurements to both of them it seems like it's somewhere in the middle.