FS(OR) MSM head, cams, two sets of stock valve springs and valves, supertech valves
Thread Starter
Junior Member
iTrader: (8)
Joined: Jul 2008
Posts: 401
Total Cats: 9
From: Portland, OR
FS(OR) MSM head, cams, two sets of stock valve springs and valves, supertech valves
Selling some of my extra MSM parts
I have a used MSM head from an 04. Head is cleaned up and ready to build, no additional work has been done. Valve guides/seats and cam surfaces look good. I don't have a great straight edge but I don't detect any warpage.
Unfortunately I don't have the red valve cover or the intake manifold
Cams are SOLD
I have two sets of stock valves and valve springs/retainers. One set is nice and cleaned up the other just came out of my other head. Both have less than 25K on them as far as I know.
Last I have a set of standard size Supertech valves. I bought these and then went to 1mm oversize valves. They were purchased from 949racing.
I am trying to be fair on the pricing
For the head alone I would like $200 plus shipping
Cams $40(although I know some might only want the exhaust cam) if you want to buy them with the head I'll knock off $10-I don't think I have the cam gears.
For the stock valve sets I don't know is $50 fair for the clean set and $40 for the dirty set seem fair. Again if you buy the head I'll knock off $10
The supertech valves were around $285. I'll let them go for $225 plus shipping
I'll see how many photos I can post in this thread if you want photos of the valves etc I have them.
I have a used MSM head from an 04. Head is cleaned up and ready to build, no additional work has been done. Valve guides/seats and cam surfaces look good. I don't have a great straight edge but I don't detect any warpage.
Unfortunately I don't have the red valve cover or the intake manifold
Cams are SOLD
I have two sets of stock valves and valve springs/retainers. One set is nice and cleaned up the other just came out of my other head. Both have less than 25K on them as far as I know.
Last I have a set of standard size Supertech valves. I bought these and then went to 1mm oversize valves. They were purchased from 949racing.
I am trying to be fair on the pricing
For the head alone I would like $200 plus shipping
Cams $40(although I know some might only want the exhaust cam) if you want to buy them with the head I'll knock off $10-I don't think I have the cam gears.
For the stock valve sets I don't know is $50 fair for the clean set and $40 for the dirty set seem fair. Again if you buy the head I'll knock off $10
The supertech valves were around $285. I'll let them go for $225 plus shipping
I'll see how many photos I can post in this thread if you want photos of the valves etc I have them.
Last edited by kaisersoze; Feb 3, 2010 at 12:39 PM.
Reply
0
0
If the cams are good, I want. Sending PM.
If you have the intake side cam gear, it would be cool. If not, I still want the cams.
If you have the intake side cam gear, it would be cool. If not, I still want the cams.
Reply
0
0
PM'd at 8:30am.
Reply
0
0
Lame-o. You don't even have a miata.
Reply
0
0
Yeah the casting is the same, 99/00/MSM
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Rudes333
Miata parts for sale/trade
17
Nov 5, 2015 01:16 PM
