FS: RX7 550cc injectors + other stuff
Thread Starter
Elite Member
iTrader: (10)
Joined: Dec 2006
Posts: 4,064
Total Cats: 10
From: Pembroke Pines
FS: RX7 550cc injectors + other stuff
I NEED TO SELL THIS STUFF SO I CAN GET MY CAR RUNNING AGAIN!
INJECTORS SOLD!!!
My second set of Mazdaspeed Sway bars off of my MSM: Asking 130 shipped in the usa for the both.
Partial AEM Meth injection kit. The main control board took a **** so basically the pump, the lines, nozzles, 1 gallon tank and jets are whats for sale. You can get a boost pressure switch for 30 bucks from devils own and get it running. Asking 220 shipped in the usa for all of it.
My old SPA turbo. (Copied from my other FS thread) The specs are: .36 Turbine and .63 compressor. Saying it spools slow is an understatement. About as slow as a booger trying to roll up a wall....when its snowing outside.
It has lots of up and down shaft play but doesnt contact the compressor housing...yet. Get it rebuilt and then no worries. Its worked fine and still did up until lastnight when i took it off and replaced it. You can take a chance if you like and just bolt it on but i cant tell you how long itll last for. I saw full boost at 4700 rpms. Started spooling at 3800 rpms. Its got about 9k miles on it. Yeah, that speaks for the quality of this gem.
Asking $100 shipped in the usa for this beautiful POS:
INJECTORS SOLD!!!
My second set of Mazdaspeed Sway bars off of my MSM: Asking 130 shipped in the usa for the both.
Partial AEM Meth injection kit. The main control board took a **** so basically the pump, the lines, nozzles, 1 gallon tank and jets are whats for sale. You can get a boost pressure switch for 30 bucks from devils own and get it running. Asking 220 shipped in the usa for all of it.
My old SPA turbo. (Copied from my other FS thread) The specs are: .36 Turbine and .63 compressor. Saying it spools slow is an understatement. About as slow as a booger trying to roll up a wall....when its snowing outside.
It has lots of up and down shaft play but doesnt contact the compressor housing...yet. Get it rebuilt and then no worries. Its worked fine and still did up until lastnight when i took it off and replaced it. You can take a chance if you like and just bolt it on but i cant tell you how long itll last for. I saw full boost at 4700 rpms. Started spooling at 3800 rpms. Its got about 9k miles on it. Yeah, that speaks for the quality of this gem.
Asking $100 shipped in the usa for this beautiful POS:
Last edited by leatherface24; Jul 13, 2010 at 02:54 PM.
Reply
0
0
Reply
0
0
