FS:Toyota COPs + pins and cap
Thread Starter
Junior Member
iTrader: (7)
Joined: Feb 2007
Posts: 394
Total Cats: 6
From: Overland Park, KS
FS:Toyota COPs + pins and cap
$40 Shipped CONUS
These are longer than the Toyota COPs most people on MT.net use, therefore they do not sit down flush with the valve cover.
The pins and high temp capacitor were supplied by Braineack.
There are enough pins to make two harnesses. Just grab some connectors (Toyota P/N 90980-11885) and you are ready to build a custom COP setup.
Connectors can be purchased here: http://www.discounttoyotaparts.com/
These are longer than the Toyota COPs most people on MT.net use, therefore they do not sit down flush with the valve cover.
The pins and high temp capacitor were supplied by Braineack.
There are enough pins to make two harnesses. Just grab some connectors (Toyota P/N 90980-11885) and you are ready to build a custom COP setup.
Connectors can be purchased here: http://www.discounttoyotaparts.com/
Last edited by MazDilla; Jan 8, 2011 at 01:08 PM.
0
Thread Starter
Junior Member
iTrader: (7)
Joined: Feb 2007
Posts: 394
Total Cats: 6
From: Overland Park, KS
10,000 micro Farads
16V
105 degrees C
I put them on the car and snapped a pic just for you. You could trim the boots if you want them to sit lower. Also a hold down bracket would also cover this space and make them sit nice and flush.
16V
105 degrees C
I put them on the car and snapped a pic just for you. You could trim the boots if you want them to sit lower. Also a hold down bracket would also cover this space and make them sit nice and flush.
0
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
Apr 21, 2016 03:00 PM
