Garage Cleanout - OEM NA/NB Stuff for Cheap
#1
Senior Member
Thread Starter
Join Date: Jun 2022
Location: Aliso Viejo, CA
Posts: 905
Total Cats: 183
Garage Cleanout - OEM NA/NB Stuff for Cheap
Got a bunch of stock NA/NB stuff sitting around my area at work that I'm never going to use. Y'all on here have helped me a bunch in the last year and I don't usually have much to contribute on the forum except for helping answer noob questions. I'm going to consider this as me giving back to the forum haha.
I'm asking $20 on each part plus shipping. $30 for the clutches/flywheels (together). I'll add more parts next week.
VTCS intake manifold and NB throttle body w/ TPS. Upper to lower manifold gasket included.
NB2 fuel rail, injectors, and harness.
NB2 ignition coils and harness
Stock motor mounts and brackets (no hardware).
NB2 alternator
Two NA8 fuel rails. One off my car with 207k miles. Other rail mileage unknown.
I also have two OEM clutches - one with about 3k miles on it and another with unknown mileage but very little wear. To go with these, I also have two OEM 1.8L flywheels both in good condition. I'll post pics of those next week.
Thanks for looking!
-Zak
I'm asking $20 on each part plus shipping. $30 for the clutches/flywheels (together). I'll add more parts next week.
VTCS intake manifold and NB throttle body w/ TPS. Upper to lower manifold gasket included.
NB2 fuel rail, injectors, and harness.
NB2 ignition coils and harness
Stock motor mounts and brackets (no hardware).
NB2 alternator
Two NA8 fuel rails. One off my car with 207k miles. Other rail mileage unknown.
I also have two OEM clutches - one with about 3k miles on it and another with unknown mileage but very little wear. To go with these, I also have two OEM 1.8L flywheels both in good condition. I'll post pics of those next week.
Thanks for looking!
-Zak
Last edited by Z_WAAAAAZ; 10-18-2023 at 11:30 PM.
#2
Senior Member
Thread Starter
Join Date: Jun 2022
Location: Aliso Viejo, CA
Posts: 905
Total Cats: 183
Stock 10:1 pistons and rods from an NB2. Believe these to have ~100k miles on them. Lower caps included, just not pictured. Again, $20 for the whole set.
Generic 59" NRG wing. 10" height. The female inserts for the endplate fasteners on one side spin freely in the mold so I epoxied the endplate on in addition to the fasteners. It's seen speeds of up to 135mph and has held fine. Noticably increased rear downforce, but probably not as much as an APR or something with stiffer mounting points. I paid $500 for it. $100obo takes it.
Thread
Thread Starter
Forum
Replies
Last Post
thumpetto007
Miata parts for sale/trade
5
05-13-2019 10:49 AM
muthagoose
DIY Turbo Discussion
3
08-16-2018 02:18 PM
customfab87
Miata parts for sale/trade
2
03-10-2017 12:29 AM