Garrett Turbo $150 + shipping
Hey Dudes,
I know I haven't posted here in a while, but I am cleaning out the garage and I forgot I had this turbo. It has been sitting around packed up in a box with a light coat of oil on it. I was going to use it as a basis for a DIY build and even when so far as to ship it to Corky Bell and had him check it out to see if I could use it as part of a Shanghi kit, but it was going to cost too much to modify everything. By the way he said it checks out fine. So I know the turbo is good. It is a turbo from a Nissan 300ZX single turbo set-up and is in excellent condition. It is a Garrett turbo made in Japan for Nissan. According to a thread here where we discussed it at length it is basically a T25 turbo, but it has a T3 inlet flange. I should perform like a 2554. Here is the three page thread where there are pictures of the turbo disassembled: https://www.miataturbo.net/showthrea...an+300zx+turbo Make sure you read page 2 where there are maps and stuff. https://www.miataturbo.net/attachmen...1&d=1239146181 https://www.miataturbo.net/attachmen...5&d=1238721441 https://www.miataturbo.net/attachmen...3&d=1238898920 |
can you measure the CHRA?
nvm |
this turbo interests me... but it requires two flanged adapters on the compressor housing doesnt it?
|
Originally Posted by Braineack
(Post 767816)
this turbo interests me... but it requires two flanged adapters on the compressor housing doesnt it?
On he exhaust outlet side there is an extra cast iron elbow tha bolts to the turbine housing and turns down. It has a threaded fitting for a sensor and ends in a 3 bolt flange that looks to be a standard type exhaust flange. It is cast iron and it is OEM. |
Originally Posted by Techsalvager
(Post 767798)
can you measure the CHRA?
nvm |
Center housing rotating assembly. |
Originally Posted by thegrapist
(Post 767827)
Center housing rotating assembly. |
Well... It was worth a try anyway. I must have been mistaken thinking that someone on here would want this turbo for a low budget custom set-up. Thanks anyway guys.
|
So cute!
|
I'd be all over it if it was a T25 flange.
|
Originally Posted by 92Black&Tan
(Post 770987)
Well... It was worth a try anyway. I must have been mistaken thinking that someone on here would want this turbo for a low budget custom set-up. Thanks anyway guys.
|
All times are GMT -4. The time now is 10:00 PM. |
© 2024 MH Sub I, LLC dba Internet Brands