Tubular Manifold and Garrett Turbo
#1
Elite Member
Thread Starter
iTrader: (12)
Join Date: May 2007
Location: Austin, TX
Posts: 1,881
Total Cats: 2
Tubular Manifold and Garrett Turbo
This manifold will place your turbo pretty low and about as far back as possible. I have no idea who made it because it was on my car when I purchased it. It has right around 20K on it and has held up great so far. The EGR fitting was cut off for a buyer that ended up backing out, so it will need one welded on or just patched if you run without. The turbo is a Garrett and has the same mileage on it as the manifold. I don't really know anything about it other than it's tiny. I am selling them together because I know they will fit (they did on my car). If you were to go with a bigger turbo you might run into clearance issues because it is very tight.
Additional pictures of the turbo can be found in this thread:
https://www.miataturbo.net/forum/t31264/
There's also a few pictures of how it looked on my car in my build thread.
I would like to get $220 shipped.
Additional pictures of the turbo can be found in this thread:
https://www.miataturbo.net/forum/t31264/
There's also a few pictures of how it looked on my car in my build thread.
I would like to get $220 shipped.
Last edited by JayL; 02-15-2009 at 11:43 PM.
#10
Elite Member
Thread Starter
iTrader: (12)
Join Date: May 2007
Location: Austin, TX
Posts: 1,881
Total Cats: 2
If someone is truly interested, I have other items from this setup as well. There's a downpipe, midpipe, exhaust, crossover tube, water reservoir, water/air intercooler setup. It's all nothing special though, and most of it is missing bolts and stuff.
Thread
Thread Starter
Forum
Replies
Last Post