Like New Begi S Kit, Intercooled with extras
Thread Starter
Junior Member
iTrader: (3)
Joined: Mar 2008
Posts: 220
Total Cats: 0
From: Sunnyvale, ca
This kit was on my 1999 for approximately 2,000 miles with the wastegate actuator open so no boost was ever made. (No engine management) The turbo has no shaft play and is essentially brand new, never made boost. The other components are also in like new condition except for heat caused wear of coating on manifold and downpipe. All hardware is included in this kit except for the air filter; that’s the only thing you would need to get all this on your car, its my complete kit. You will get:
Begi Exhaust manifold
Garret t2554 turbo
Begi Downpipe
All sillicone couplers and t-bolt clamps
Piping from air filter to turbo (all piping is already cut and ready to be installed)
Hot side piping (2")
2" to 2.5" reducer
CXracing intercooler (2.5 inch endtanks)
DIY bracket for mounting intercooler
Cold side piping (2.5")
Greddy s knock off bov, with flange in coldside piping
signal line for bov
Bung welded in coldside for GM iat
Gm iat with pigtail
all fittings, lines everything else needed to get this on your car.
I had to pay $100 for shipping, plus the intercooler, brackets, piping, bov, welding the bung for iat, the iat, etc was at least another $300+, in addition to me having to fit all the stuff, cut it to make it work etc.
I am asking to $1700.00 for everything.
Henry

[img][/img]









Begi Exhaust manifold
Garret t2554 turbo
Begi Downpipe
All sillicone couplers and t-bolt clamps
Piping from air filter to turbo (all piping is already cut and ready to be installed)
Hot side piping (2")
2" to 2.5" reducer
CXracing intercooler (2.5 inch endtanks)
DIY bracket for mounting intercooler
Cold side piping (2.5")
Greddy s knock off bov, with flange in coldside piping
signal line for bov
Bung welded in coldside for GM iat
Gm iat with pigtail
all fittings, lines everything else needed to get this on your car.
I had to pay $100 for shipping, plus the intercooler, brackets, piping, bov, welding the bung for iat, the iat, etc was at least another $300+, in addition to me having to fit all the stuff, cut it to make it work etc.
I am asking to $1700.00 for everything.
Henry

[img][/img]









Thread Starter
Junior Member
iTrader: (3)
Joined: Mar 2008
Posts: 220
Total Cats: 0
From: Sunnyvale, ca
Thread Starter
Junior Member
iTrader: (3)
Joined: Mar 2008
Posts: 220
Total Cats: 0
From: Sunnyvale, ca
hey really interested. can you email me at lilaznjoker@gmail.com
Thread
Thread Starter
Forum
Replies
Last Post





