Price drop on all!!
Time for Phase 2 of the miata partout. This will be a complete part out of my car so if there is anything you need feel free to ask. The only thing I don't want to ship are the large parts and body panels.

Trackspeed 11.75" BBK. I bedded the pads in, and drove the car for about 300 miles with this phenomenal set up. It will come as shown with the calipers, lines, rotors (safety tied already), and the wilwood proportioning valve with fittings. The pads on it are Hawk HP+. The silver on the top hats of the back side on the rotors is just anti-seize. $SOLD.

Coolant re-route set up. Will come as shown with the adapter plate, thermostat housing, hose, and block off plate, water neck and sensors not included. $SOLD

Borg Warner EFR 6258 Turbo. This has never been mounted, and has just been sitting in my house in the box for a for a few years now. My build plans never came too. In my eyes this is one of the best turbo's for a 1.6 or 1.8. Quicker spool than a gt2560r AND more power up top! It will come with the full race flange and clamp as well. $1225 shipped

Afco Coilovers. I just had the rears rebuilt by rightfoot performance due to a leaking seal on one. They have been fantastic shocks for me and have about 5000 miles on them. The rears have not been installed since rebuild. The only issues with them that I an think of is that the top hap bushings are getting a little dry, and the set screws had seized on the adjusting collars, but you can still adjust them. They will come with the springs shown, and I will assemble the rears with the springs and top hats prior to shipping. The fronts have extended top hats currently installed, but will come with the flat top hats as well for more droop. $1100 shipped.

ATI Damper. This is brand new and has never been mounted. I bought it late this past winter. It will come with the crank key and bolt for a BNC 1.6. The belt guide is also included. IF you are going to be installing this on a 1.6, I would be willing to work a deal with a 1.8 alternator and water pump pulley that is needed to run with this damper. $465 shipped.

Vishnu 1.6 Fuel rail. This is in very good shape and comes with newly installed Russel -6an fittings. $SOLD

All prices shipped in the lower 48. Also, a pic of my car below for reference if there is anything anyone would be interested in from it.

 

Pm sent

 

What are the specs on the springs for the AFCOs?

 

Bump! Lots of goodies still available!

 

More info on coolant reroute?

 

Sorry it is sold.

 

Could I ask what spring rates are on the AFCOs?

 

Interested in the BBK. Are those directional or straight vane rotors?

 

If it has an open diff I'm interested in the spider gears

 

Price drops!!

 

I am open to reasonable offers on the parts too!

 

Would you do $350 shipped for the wilwoods and rotors?

 

Pm'd

 

Would the ATI damper work with a 1.8? (99)

 

Haha...sorry but I will decline this offer. You would have nearly $800 into this set up if you were to buy new, and this is about as close to new as a used set gets. So, save close to a couple hundred bucks, and get it sooner than you would from trackspeed.

 

I didn't see an answer to the spring rate question that others asked - what are the rates? Are these the FM units?

 

These are the Flyin' Miata Afco's. The springs shown pictured off the shocks are 300#, 375# and 700#. I forget off hand which springs are currently on the front shocks. I want to say they are either 350# or 400#.