Shaneg217

How so?

Nvm I googled it. It is pulled slightly over but would that really matter that much?

ysleem

iTrader: (5)

Yes. It happened to me also on that turbo.

SchmoozerJoe

iTrader: (2)

And while I can't say if the alignment procedure is identical for the MKTurbo provided turbos, Andrew threw a quick video up on YouTube on how to align the actuator on the EFR turbos

Shaneg217

So I aligned the actuator almost perfect. Still won't close the wastegate when hot.

shuiend

iTrader: (24)

You got an email. I am guessing something in the v-band outlet housing where the wastegate actuator passes through isn't perfect and that is causing the issue.

tehzack

MK Turbo kit's can sneak you into the 11sec quarter territory with a bigger billet wheeled ebay turdbo:

cpierr03

FYI this is the same turbo I posted (but haven't yet installed) in post #1986.

@tehzack , any idea on rough power level @ 20PSI?

Also, wondering how much wastegate porting you've done, I've hogged out quite a bit from the turbine housing in anticipation...

tehzack

Haven't dyno'd it yet. I have to imagine it's over 300whp if it's running 1/8th miles that equivalate to 11.6-11.7 1/4's.

I just traced the flapper on the wastegate and ported to roughly that size. I didn't go crazy on it.

Supermoto65

Did you use the internal wastegate vband adapter from the original MK turbo kit? I tried on another larger turbo I bought and the flapper was way off. I looked at others on ebay but they all look the same ...

cpierr03

Check post 1986.

I purchased one that apparently Lars uses as well. It lined up alright, I ended up bending it a bit to get better coverage so I could port more.

Haven't tried it with the one Lars originally sent but I suspect it would be the same.

tehzack

Dyno'd the new setup today. 350whp/323wtq at 250kpa on 93 octane (not going to re-visit that boost for street usage)

shuiend

iTrader: (24)

I am finally getting with the 21rst century and launching a Facebook page. You can find it HERE.

For the launch I am running a sale until the end of April. $100 off DIY setups, $150 off IC setups, $200 off complete setups. Currently lead times are about 2 weeks for most setups. I have slowly been working on getting ahead and have a ton of parts finished on hand.

HowPrayGame

That page looks great, do you remember what car meet the Raymond James photo is from?

shuiend

iTrader: (24)

Which picture specifically are you talking about?

HowPrayGame

This one

97eunos

Do you have the page settings private or to America only? Tried clicking the link it says it's broken, searched using Facebook and cannot find the page.

shuiend

iTrader: (24)

That was MiataPalooza 2017.

It might be set to US only, I would have to go check. I don't ship out of the continental US due to costs.

97eunos

I did order a complete setup but just to the border storage

shuiend

iTrader: (24)

I went and checked the page settings. It should be open to the world. Not sure why exactly you can't get to it.

Nik Still

Diagrams for Which Rubber and pipe goes where? Ive got 3 of the silicone adapters, 2 Fit the E sized pipe, one Fits the smaller. Obviously E pipe goes from the intake, just dont know about the others.

On a side note, anyone had any luck keeping the compressor housing from rusting? High temp Paint?