I'm upgrading to an MS2, and no longer need this one.

It was built by Wayne_Curr on the forums back in...2010? +/- a year.

It's running on the latest hi-res code, and works with VTPS and launch control (that's the single red wire running outside the harness), and has JP's spark output mod, so you don't have to run inverted spark, and I don't think you have to unplug the ignitor while loading firmware anymore. Don't quote me on that though, it's been a while.

I'll rewrap everything once it comes off the car to hide the LC wire though. MS case has been well protected over the years, but the patch harness has some overspray on it.

The patch harness was made by Braineack, and is bolted to a small piece of sheet metal, so you can bolt it to the floor like I did. Not 100% it'll all fit under the kick panel like that, but the little piece of sheet metal is removable.

Looking for $350 shipped, or a local can have it installed* by me for $400.

*does not include highly recommended wideband install.





Includes the MS and patch harness, no serial cable for now. Available for ~$10 at your local electronics store.

The only two wires you'll need to run is the launch control to ground (or a switch, then ground, if you want to turn it on/off), and the purple wire shown to your fuel pump relay.

 

I'm very happy with my MS1.
I'm using it with LS2 coils, Deatschwerks 700cc injectors, and a GTX2867R, and I've still got A/C.

Good luck with sale.

 

PM inbound.

 

So this is basically plug and play with your supplied harness other than the fuel relay? Im not worried about the launch control at this point.

 

Yes, however sale is pending. I'll mark the thread as sold once sale is finalized.

 

Sold to Monk, thanks!