MS3 Basic + CAN & ID 725 for 99-00
05-31-2018, 06:28 PM
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Oct 2013
Location: Goleta, Southern California
Posts: 520
Total Cats: 27
MS3 Basic + CAN & ID 725 for 99-00
I sold my car.
The MS3 and CAN module were purchased from Trackspeed a few years back.
The MS3 basic was running my car with stock injectors for the last couple of months.
I am unsure if the CAN module is working, because I never did get it working again once I started putting things back on (after SMOG). When I pulled it off for sale of the vehicle, I'm fairly certain I had just hooked it up incorrectly. However my uncertainly leads me to "give" the CAN module away with the MS3. I will not sell it separately.
Asking $800 shipped for the MS3/CAN module. It can hurt to shoot me a lower price but I'm going to let it ride for a week or so at this price.
Also included are the 3bar MAP and GM IAT sensor, and Singular mounting bracket.
The ID 725's were purchased used a few years back from someone on this board. They away worked flawless for me. Could probably use a cleaning, but not mandatory. the Adapter harnesses go with the injectors. Will probably also want new o-ring which can be had for dollars at a local parts store.
Asking $200 shipped.
Or you can just buy it all for $900 shipped.
The MS3 and CAN module were purchased from Trackspeed a few years back.
The MS3 basic was running my car with stock injectors for the last couple of months.
I am unsure if the CAN module is working, because I never did get it working again once I started putting things back on (after SMOG). When I pulled it off for sale of the vehicle, I'm fairly certain I had just hooked it up incorrectly. However my uncertainly leads me to "give" the CAN module away with the MS3. I will not sell it separately.
Asking $800 shipped for the MS3/CAN module. It can hurt to shoot me a lower price but I'm going to let it ride for a week or so at this price.
Also included are the 3bar MAP and GM IAT sensor, and Singular mounting bracket.
The ID 725's were purchased used a few years back from someone on this board. They away worked flawless for me. Could probably use a cleaning, but not mandatory. the Adapter harnesses go with the injectors. Will probably also want new o-ring which can be had for dollars at a local parts store.
Asking $200 shipped.
Or you can just buy it all for $900 shipped.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
