MS3 Pro adapter board
11-24-2016, 05:45 PM
#1
Senior Member
Thread Starter
Join Date: Nov 2007
Location: Belgium
Posts: 999
Total Cats: 73
MS3 Pro adapter board
Selling an assembled baseboard for a MS3 Pro module, with map sensor and bluetooth already installed. 2nd sensor for Baro is an extra $30.
This has hardware alternator control so you don't have to mess with the settings in Tunerstudio. It's rock solid within 0.1V under any condition.
Voltage can be adjusted with the gray trimmer at the bottom.
There's a circuit for a 3 stage shift light (output through the RJ45 jack), 2 VR to Vss circuits, 1 VR conditioner circuit, etc ...
This is the 99-00 version and can be converted to 90-95 by swapping over the connector.
Completely plug and play.
This is the 'older' V2 version but it actually has more circuits than the current V3 version. V3 lacks the VR to Vss circuits and the VR conditioner circuit (nobody needs the so I removed them).
Only thing V3 has more is the option for Wifi instead of Bluetooth. V2 can do wifi as well, but there's no spot for it on the board, so you'll have to install it in the proto area and run 4 extra wires.
Price is $60 shipment included.
More pics in https://goo.gl/photos/S3qbfvoYroQgijyb7
This has hardware alternator control so you don't have to mess with the settings in Tunerstudio. It's rock solid within 0.1V under any condition.
Voltage can be adjusted with the gray trimmer at the bottom.
There's a circuit for a 3 stage shift light (output through the RJ45 jack), 2 VR to Vss circuits, 1 VR conditioner circuit, etc ...
This is the 99-00 version and can be converted to 90-95 by swapping over the connector.
Completely plug and play.
This is the 'older' V2 version but it actually has more circuits than the current V3 version. V3 lacks the VR to Vss circuits and the VR conditioner circuit (nobody needs the so I removed them).
Only thing V3 has more is the option for Wifi instead of Bluetooth. V2 can do wifi as well, but there's no spot for it on the board, so you'll have to install it in the proto area and run 4 extra wires.
Price is $60 shipment included.
More pics in https://goo.gl/photos/S3qbfvoYroQgijyb7
Reply
0
0
12-16-2016, 09:17 AM
#7
Junior Member
Join Date: Dec 2008
Location: Ft. Lauderdale, FL
Posts: 315
Total Cats: 9
I have been working with a buddy of mine getting one of these boards and a MS3 Pro module installed in his racecar and I can say that we have been given GREAT customer service and it is making any issues we may encounter easy to diagnose and correct. I would NOT hesitate to buy another board from him. Top notch service! Thanks again!
Reply
1
1
