NB 1.8 TechnoToyTuning ITB Setup
Have a new T3 ITB setup w/ Silvertop 4AGE throttle bodies (the throttle bodies have been gone through, just lubricated and cleaned them... haven't been set with a manometer yet), with the larger velocity stacks, new UNI filters and a new TPS. I have the original manifold from the Toyota, and plenum (painted black because the silver was flaking off a bit). Bought stainless hardware from ACE for the ITBs + stacks.
Decided to go to turbo, and as much as I'd like to get this running with the turbo, as a daily I feel like I might have idle issues in stop and go traffic boosted w/ them.
That being said, I'm not really sure what to ask for them cash wise, I think the manifold + stacks were around $500 + shipping, the filters were ~$80 IIRC, TPS was $20 and the ITBs were a few hundred.
I am more interested in trading for turbo parts, engine internals, stiffening parts (door bar, front brace, rear brace, frame rails), gauges + a pillar pod, maybe even seats or a wing... Open to cash offers, too, I suppose.
Thanks!
Decided to go to turbo, and as much as I'd like to get this running with the turbo, as a daily I feel like I might have idle issues in stop and go traffic boosted w/ them.
That being said, I'm not really sure what to ask for them cash wise, I think the manifold + stacks were around $500 + shipping, the filters were ~$80 IIRC, TPS was $20 and the ITBs were a few hundred.
I am more interested in trading for turbo parts, engine internals, stiffening parts (door bar, front brace, rear brace, frame rails), gauges + a pillar pod, maybe even seats or a wing... Open to cash offers, too, I suppose.
Thanks!
I actually just got the Kraken manifold/elbow/downpipe and a GT2554R, was more thinking like intercooler, boost/egt/oil temp gauges, BOV, boost controller, low compression pistons, forged rods, cams or springs. Thank you though - that was a really fast response
I would separate them if I had people wanting both of them but I wouldn't sell it at $300, that's less than the cost of either of those parts individually. PM me if you're interested and we might be able to work something out
Thread
Thread Starter
Forum
Replies
Last Post






