RX7 3.9 Ring and Pinion
#1
RX7 3.9 Ring and Pinion
Bought this a while back to swap into my torsen diff and ended up not going through with it. Now that I've bough the Mfactory 3.33 unit, I have no use for it. This thread specifies that if you swap the pinion bearing over from the miata diff, everything bolts up as it should. I have personally measured the pinion against a 4.10 mx5 piece with a dial caliper and the length of the two are the same along with the diameter of the section where the main bearing sits. Asking $300 shipped for the set. Located near NYC for anyone who wants to pick up for a little better deal.
Thread
Thread Starter
Forum
Replies
Last Post