Turbo build leftover bits and baubles
Thread Starter
Senior Member
iTrader: (7)
Joined: Oct 2011
Posts: 705
Total Cats: 21
From: Horse and Buggy, PA
Turbo build leftover bits and baubles
My build has held together pretty well since finishing it up this spring so I think it's time to let all my extra pieces go. Make no mistake these are leftovers, but maybe something here is just what you need.
IC piping assortment - hotside metal pipe (basically follows FM's routing), 2 silicone couplers (plus random rubber ones), 1 90 degree silicone elbow, 4 t-bolt clamps, the crossover tube for recirc and a metal intake elbow with a boss for the recirc. - $45 + shipping SOLD
SR20 T25 outlet with the two long bolts needed - $10 + shipping SOLD
SR20 T25 hard oil feed and water line. I'll also throw in some leftover silicone water lines so you can fab one combo hard/soft water line. $20 + shipping OBO
DIY turbo heat shield - will need finished for your application but it's a start $40 + shipping OBO
Rear main and one camshaft seal - new, never installed (outside of bag has smudges but the seals are new) $20 shipped for both OBO
1995 miata oil pressure gauge and sender - does anybody even want these?
SR20 T25 hard oil feed and water line. I'll also throw in some leftover silicone water lines so you can fab one combo hard/soft water line. $20 + shipping OBO
DIY turbo heat shield - will need finished for your application but it's a start $40 + shipping OBO
Rear main and one camshaft seal - new, never installed (outside of bag has smudges but the seals are new) $20 shipped for both OBO
1995 miata oil pressure gauge and sender - does anybody even want these?
Last edited by RedCarmel; Nov 17, 2013 at 08:16 PM.
0
Thread
Thread Starter
Forum
Replies
Last Post
