Turbo car part out
#1
Elite Member
Thread Starter
iTrader: (41)
Join Date: Jan 2006
Location: Seabrook, TX
Posts: 2,417
Total Cats: 20
Turbo car part out
This car is being turned into a spec car so everything on it must change.
Hard Dog M1 Sport roll bar with the high density padding. Bar has scratches here and there, but overall is a 7.5/10. $250 picked up with all mounting hardware.
FM Sway bar set for 94-97 $150 + Shipping
Link ECU for 94-95. Comes with AIT and Map sensor, keyboard, serial link, boost controller, knock sensor, and a serial cable. $350 plus shipping
Oil cooler kit with Setrab Cooler and Mocal Thermostat/adapter sourced from FM and the lines were made by a hydraulic hose shop. Mounts in the same location as the FM kit. $250 + Shipping
Hard Dog M1 Sport roll bar with the high density padding. Bar has scratches here and there, but overall is a 7.5/10. $250 picked up with all mounting hardware.
FM Sway bar set for 94-97 $150 + Shipping
Link ECU for 94-95. Comes with AIT and Map sensor, keyboard, serial link, boost controller, knock sensor, and a serial cable. $350 plus shipping
Oil cooler kit with Setrab Cooler and Mocal Thermostat/adapter sourced from FM and the lines were made by a hydraulic hose shop. Mounts in the same location as the FM kit. $250 + Shipping
Last edited by rharris19; 01-21-2011 at 11:11 PM.
#4
If you've got a good, black, loop carpet interior I need the parcel shelf and vertical behind-the-seats pieces along with some other interior do-dads. I'm in Houston for a couple more days, and will be back again around the 21st.
Nevermind: realized both parts are most likely cut for the rollbar...
Nevermind: realized both parts are most likely cut for the rollbar...
#7
Elite Member
Thread Starter
iTrader: (41)
Join Date: Jan 2006
Location: Seabrook, TX
Posts: 2,417
Total Cats: 20
If you've got a good, black, loop carpet interior I need the parcel shelf and vertical behind-the-seats pieces along with some other interior do-dads. I'm in Houston for a couple more days, and will be back again around the 21st.
Nevermind: realized both parts are most likely cut for the rollbar...
Nevermind: realized both parts are most likely cut for the rollbar...
#16
I need more info about turbo kit you listing for sale, please contact me via email craps10@hotmail.com. i don't have enough post to get PM
#19
Elite Member
Thread Starter
iTrader: (41)
Join Date: Jan 2006
Location: Seabrook, TX
Posts: 2,417
Total Cats: 20
This link is a full stand alone and not a piggy back. There is no one steup that it works better on, but allows you to tune the ecu for whatever your setup is. The Link ECU is very easy to use and pretty straight forward.