Up for sale is my 5/8's oil drain kit. I am supplying 2ft of high pressure/high temp hose with clamps, 5/8's hose barb, as well as a 5/8's bit, and 3/8's N.P.T Tap, and some thread locker to round it off.

The tap and bit sales for 19.50 from Begi. I am offering the tap, bit, clamps, hose, barb fitting, and thread dressing all for 30 dollars shipped.

I pretty much used the bit and tap for my oil drain line and I no longer need it...

My price that I paid for all this is below...

19.99 for the 58's bit.
13.50 for the 3/8 N.P.T tap.
3.00/ft for 5/8's hose.
2.50 for the 5/8's hose barb.
75 cents for two hose clamps.
2.00 for thread locker.

41.00 dollars total.

 

Does anybody want this oil drain line installation kit for 19.50 plus shipping?

 

Is that heater hose or nitrile/ oil resistant rubber?

 

Heck I used 5/8's heater hose with heat protecting insulation near the turbo. I figure it should be fine. I am using 5/16 transmission cooler line for my oil feed as well...

If mine last me one year, as is advertised with the BEGI S series oil feed and oil drain lines, then i'll be happy.

 

Cody is that the tap and die from the Begi kit that you sold me?

 

Yea, be prepared, 3 - 6 months, Heater hose will start to look spongy, and gooey... It will not stand up to petrolium products. You will need to replace with fuel grade hose.

I did EXACTLY the same a while back, Now with fuel grade, its fine.

 

You should be using high temp silicone "oil-safe" type hose. That heater line will fail promptly with oil running through it. Even with a gravity fed source, I wouldn't use it.

 

25 bucks shipped to me and I'm sold