Base map for MS3 Basic
#1
Base map for MS3 Basic
Hi Reverant,
I bought your MS3 Basic last year for my turbo car. I'd like to swap it over to my SCCA car, which is naturally aspirated. I'd like to buy a base map from you so I can swap this onto my other car. The season is coming and I'll be installing my engine this month—I'd like to have it running. Please let me know if you can do this. Thanks.
I bought your MS3 Basic last year for my turbo car. I'd like to swap it over to my SCCA car, which is naturally aspirated. I'd like to buy a base map from you so I can swap this onto my other car. The season is coming and I'll be installing my engine this month—I'd like to have it running. Please let me know if you can do this. Thanks.
#2
Moderator
iTrader: (12)
Join Date: Nov 2008
Location: Tampa, Florida
Posts: 20,675
Total Cats: 3,017
You should only need to rescale your req_fuel for the stock (or just different) injectors. The map scaling above the 101kpa area will never come into use but won't hurt anything to be there. The system interpolates between cells so everything is just fine if your new configuration never goes into boost.
I wouldn't think you'd need to do anything but change the req_fuel, and injector deadtime (unless you are using the same injectors for which the basemap is designed, then you would change nothing). You would run autotune in VEAL just like any install and go with it.
I wouldn't think you'd need to do anything but change the req_fuel, and injector deadtime (unless you are using the same injectors for which the basemap is designed, then you would change nothing). You would run autotune in VEAL just like any install and go with it.
#3
Thanks sixshooter, I appreciate the input. Dimitris gave me a new map today, but I'm glad to know that at least for the baseline there's not much to consider. I'll keep the factors you mentioned in mind while I am tuning.
Thread
Thread Starter
Forum
Replies
Last Post