Hi all,

I have a 99-00 MS3 Basic with 1.40 firmware. I'm trying to connect my OBDII module and had no success with my AEM X series wideband. The module will not connect. I followed the directions from Trackspeed engineering website for the AEM wideband but still to no avail. Is there a different ini file for the module to run the AEM wideband? I also tried using both AEM options from the "CAN Wideband/EGT Module Settings". I've attached the photos of my settings and the ini file I'm running v104.
I've pinged @Reverant a few times via email and no luck.













http://www.mslabs.gr/can_module_104.zip

 

I received a response from Reverant via email. Once I find a solution I'll post it here.

 

Please do!
I didn't realize there were version numbers printed right on the PCB mask, I might have to pop mine open and take a look.