9093MSPNP Tach output
 

So ive decided to go with a IGN-4 Coil setup with Diyautotune's Quad spark coil driver, But i have a question about the Tach output. I built the circuit linked below, but for the input do i just tie both ignition outputs together into it? or do i need to make a separate circuit for each ignition output? Thanks for the help guys!

That circuit is designed to be driven via a dedicated "tach out" pin of the Megasquirt, unrelated to the actual ignition wires. I'll have to do some digging to see if the MSPnP supports this on the 1.6 model. (Or the folks from DIY will hopefully chime in shortly.)

Would the "tach out" pin not be the same as the combined output of the two ignition outputs? It should just be a 5v pulse every time there is a spark right?

The Gen 2 has a tach output, the original MSPNP doesn't.

Combining the two 5 volt spark outputs would mean you lose the tach signal once the dwell starts to overlap.

Now I'm sad.... Anyway I could add the tach out circuit? Or is my only real option an aftermarket inductive tach?
Could I run the tach off the cas or a trigger wheel? Completely seperate from the ecu?

You might be able to run the tach off the CKP pin, but I can't promise it will work.

It is possible, but difficult, to make a tach output circuit and put it in the MSPNP case.

this will work:

https://www.miataturbo.net/attachmen...ine=1331305840

Thanks Brain! I'll have to give that one a try.

I'm not sure if that will work, as like Matt said, when dwell periods overlap. I would build the circuit shown in the 1st post.

yeah the first will work, this was just another option.

pretty sure both magnamx-5 and patmx5 are running the one i posted.

They are pretty much the same other than the diodes.

Brain, the inputs there (pins 31 and 36) are the standard 5v ignition outputs right?