So I go my CL BC solenoid wired in. I ran it in open loop set the table at 50 at 19hz. It clicked so its working. I upped it Hz to 39hz and its took away the clicking. But it still works good. I went into CL and set the table at 175 kpa as thats my boost target and I have read the PID instructions over and over and my numbers are way low before I even hit my target P. I feel like I am just cycling through P I D and going in circles. Is there any formula for ever x, y ,or so much x,y, or z needs to be added or subtracted? Ive read this over and over and followed the instructions and it just isn't working. Boost Control