Differences between AFM and IAT setup with MSPNP
Thread Starter
Junior Member
Joined: Oct 2009
Posts: 89
Total Cats: 0
Differences between AFM and IAT setup with MSPNP
TunerStudio reports the VE fuel table is the only difference in the the two .msq files. Is this correct?
Are there any other settings that I need to change? I just went to the IAT and it was acting at tad odd at idle on the first start, but otherwise seemed okay. This car never runs quite right till it warms up. Working on that.
Does the MSPNP use the AFM data at all?
Jon
Are there any other settings that I need to change? I just went to the IAT and it was acting at tad odd at idle on the first start, but otherwise seemed okay. This car never runs quite right till it warms up. Working on that.
Does the MSPNP use the AFM data at all?
Jon
Reply
0
0
Supporting Vendor
Joined: Sep 2006
Posts: 2,332
Total Cats: 67
The MSPNP uses the air temperature data if the AFM is plugged in, but not the air flow potentiometer.
Reply
0
0
the only difference is the internal configuration for the air temp sensors. One being the OEM one inside the AFM, the other being that of the GM sensor.
If you use the wrong firmware/project your reported air temperature readings will be off.
If you use the wrong firmware/project your reported air temperature readings will be off.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
