Originally Posted by pdexta
(Post 872902)
Is removal of the neutral safety switch and setting up the software all you have to do to get launch control working one of Brain's MSPNPs? I was under the impression you had to actually wire the clutch switch up and I couldn't ever figure it out.
I'm pretty sure I wired it up on most of the MSI units I built. When I started assembling the DIYPNP units, I didn't always add it as no one was ever using it. It's as simple as soldering up two wires. |
Which wires/pins do you use? I want to save flex for a flex fuel sensor, and run another input for water/meth map switching... I may just go without
|
usually flex. not many options on a diypnp
|
All times are GMT -4. The time now is 01:54 PM. |
© 2024 MH Sub I, LLC dba Internet Brands