LC1 issue
i wired my lc1 wideband this morning and im using a push button with an led to calibrate it.. however the led doesnt light up and the sensor isnt getting warm at all.. i have all the ground wires connected to the ecu grounds and im using the switch 12v from the engine bay (blue connector behind headlight) is there a way to check it thrugh the Megasquirt
|
anyone? i think the issue is around the calibration wire? the LED isnt lighting at all.. i can get it to light with a continuity gauge and it goes off with the push button.. the control box is getting 12v and ive put all my grounds to the ecu ground.. i just cannot get the led to work when its connected up as the manual states.. what voltage should i see from the black calibration wire?
|
It would be better to try to connect to the LC-1's serial port via LogWorks. Are you able to get a connection there?
|
Originally Posted by Matt Cramer
(Post 941889)
It would be better to try to connect to the LC-1's serial port via LogWorks. Are you able to get a connection there?
gonna get an MTX-L instead.. |
Dude, you bought an LC-1, never configured it, didn't even download the software to try, and now you're sending it back? However, I don't blame you, I'd rather have an MTX-L too.
|
Originally Posted by hustler
(Post 942256)
Dude, you bought an LC-1, never configured it, didn't even download the software to try, and now you're sending it back? However, I don't blame you, I'd rather have an MTX-L too.
|
All times are GMT -4. The time now is 11:08 PM. |
© 2024 MH Sub I, LLC dba Internet Brands