pnp sequential shift light
#1
pnp sequential shift light
so I've been reading manuals for days and came across the shift light section. of course there is nothing about it in the pnp manual that I can find. so my question is three parts.
1 is the pnp setup hardware wise to do this?
2 if it is I would assume that the output for it would be in the center harness so which pin is it.
3 what kind of output is it, ie. neg or 5v, or 12v what's the deal?
and thanks in avance.
1 is the pnp setup hardware wise to do this?
2 if it is I would assume that the output for it would be in the center harness so which pin is it.
3 what kind of output is it, ie. neg or 5v, or 12v what's the deal?
and thanks in avance.
#2
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,050
Total Cats: 6,608
No, the MSPNP is not pre-configured for this. You'd need to connect JS7 and JS8 of the main board to a couple of the spare pins on the daughterboard, and then build the external circuit described in The MSExtra Manual.
Thread
Thread Starter
Forum
Replies
Last Post