Greddy TD04H oil fitting
03-07-2009, 12:03 PM
#1
Newb
Thread Starter
Join Date: Dec 2008
Location: Finland
Posts: 27
Total Cats: 0
Greddy TD04H oil fitting
I lost that oil banjo male part and I need to know thread and how long I should buy. I don't know about banjo fittings.
All I found on google was M12 x P1.25 mm, is that even close ?
All I found on google was M12 x P1.25 mm, is that even close ?
Reply
0
0
03-09-2009, 09:14 AM
#2
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,027
Total Cats: 6,593
The oil supply fitting on the top of the TD04H-15G turbo is M10 x 1.25.
Be aware that the banjo fitting supplied by greddy is considerably thicker than what you normally see in US-made hardware, so it may be difficult for you to find just a bolt that will fit into the banjo head that you have.
This may be a good time for you to upgrade to proper teflon-lined AN style hoses.
Be aware that the banjo fitting supplied by greddy is considerably thicker than what you normally see in US-made hardware, so it may be difficult for you to find just a bolt that will fit into the banjo head that you have.
This may be a good time for you to upgrade to proper teflon-lined AN style hoses.
Reply
0
0
03-10-2009, 07:44 AM
#4
It may be easier to just replace the whole line. See this link for part numbers:
https://www.miataturbo.net/forum/t13306/
https://www.miataturbo.net/forum/t13306/
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
