Kraken G25-550 turbo questions
Hello everyone, I recently got my kraken turbo kit in and I had a few questions about stuff on the turbo. It's a .72ar t25 IWG turbo, so the IWG stuff is mainly what I wanted to ask some questions about.
Here's my questions: 1. What size hose should I need to fit onto the wasgate nipple? 2. Where can I buy a 90° fitting for my wastegate boost source? Im not quite sure what id look up to find it 3. How do I set IWG preload, and how should I know if it's too much or too little? I'll provide some pictures of the turbo below Photos: https://cimg9.ibsrv.net/gimg/www.mia...b48108e880.jpg The little hex head near the compressor is where my wastegate boost source would go, but im not sure what size thread it is, im assuming a 1/8\" NPT. https://cimg2.ibsrv.net/gimg/www.mia...c9ca4a2ab1.jpg Same question about the nipple size on the wastegate, jm assuming 1/8\". |
You run a vacuum line from the coldside IC pipe to the wastegate. You leave the port on the turbo closed.
|
All times are GMT -4. The time now is 02:26 PM. |
© 2024 MH Sub I, LLC dba Internet Brands